Ford Bantam Questions Any type
Ford Bantam Engine Replacement
Hi there. I have a 2005 Ford Bantam 1.8 diesel. I was wondering if there is an engine that would fit on that gearbox and mountings. Engine is toast and cant find parts anywhere. New head is to exs...
Im Luking For Ford Bantam Rocem Full Hanes
Ford bantam 1300 2008
Ford Bantam - 2006 - Aircon Evaporator
Hi Guys, The A/C in my Ford Bantam 2006 1.3iXL suddenly stopped working. I have owned the vehicle from new and a couple of years ago the A/C compressor was coming on and off in short intervals every ...
Fuel Consumption Is To High.
My rocam 1.3 Bantam is heave on fuel. It's been serviced. Got a slight jerk at takeoff. No other issues . Got 400 000 km on the clock
Ford Bantam Electrical Troubleshoot
Before a fire hazard accrued l was driving around and my hazards starting to indicate and would not go off ,my gages stop working my bakkie was doing its own thing and burst into flames !!! I sav...
Ford Rocam 1.3 Heat Gauge Problem
While driving long distance the heat gauge shows normal working temperature "in the middle". When I switch the bakkie off and start it again after a few minutes the heat gauge rise to almost overhe...
Bantam 2008 Rocam 1.3i
I have a 2008 Bantam rocam 1.3i The battery is being discharged when switched off and stands overnight The battery is new and when fully charged retains charge if positive terminal is disconnected. O...
Battery Light Issues?
I have a 2010 ford bantam 1.3 rocam petrol, I drove to work one morning with all normal. The afternoon when i started, the battery light did not go off, I limped home and measured the output voltag...
My Ford Bantam Cluster Is Working, But When The Battery Is Low It Show
My Ford bantam rocam cluster is not working, but when the battery is low it show, please help.
Ford Bantam Rocam 2010
Hi everyone can you please assist On my Ford bantam 1.3 rocam, I was changing the spark plugs yesterday when we done with changing the spark plugs we attempt to start,it didn't start but the engine...
Electrical Problem Cranks But Won't Start
Hi. I have a 2007 Ford bantam rocam engine. It cranks but won't start. I discovered that the computer box was replace with a bigger box which is for cars pre 2007. I did some research and changed ...
What's The Cause Of A Rev Increase ?
Hi, I have a Ford Bantam 1.3i rocam 2008 model. Start the engine, it runs well after a couple of minutes the Rev count goes up to 2000rmp, what may be the cause of this and what can be done to sol...
1985 1.6 CVH Ford Bantam Wont Start
Replaced stardard carb with 32/36 Weber carb, refurbished starter, new ignition module, new coil, plenty fuel and good spark, car wont start at all. Cranks but dont start
Ford Bantam Troubleshoot
I had an issue with electrical harness repaired that everything comes on but no power to engen !please help
My Bantam 16 Rocam Problem
perforatedlease help my bakie isnt starting i replaced a short piece of the electrical harnes that got little burnt dueb to short on the contactor if its called tyhat everything is going on as norma...
Ford 1,6 Xlt Rocam Bakkie
Hi my rocam Bakkie stalled whilst driving ,the ignition lights comes on but motor doesn't turn ,comp!etely dead ,,the light next radio completely dead too no flashes .Please advise
Starting Problems ,the 3rd Fuse From The Top Right
Hi my rocam Bakkie stalled whilst driving ,the ignition lights comes on but motor doesn't turn ,comp!etely dead ,,the light next radio completely dead too no flashes .Please advise
Can I Connect The Heater Pipes Without The Heater Connector Valve?
can i connect the heater pipes without the heater connector valve?as i can not find the new 1.
Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.