Ford Bantam Questions Any type

No Brakes

no brake flued coming out the right rear brake nipple after bleeding

How Do I Remove The Sump Off A 2006 1.8i Diesel Ford Bantam

all bolts have bee removed te sump is loose and moves around but its as if something is keeping it from coming down.

Hi All! My Ford Bantam 2003 Model 1,6i XLE Rocam Engine Is Overheating Afte...

My ford bantam 2003 model 1,6i XLE rocam engine is overheating after few minutes after I started.Fan tested and is functioning well. When I switch on the aircon the fan works fine & when it goes to re...

Hi I Have A Ford Bantam Bakkie Its A 1600i Fuel Injection I Dont Get Power ...

50

2010 WIPER RELAY,WHERE IS IT?

NEED TO FIND THE RELAY,THE WIPERS STOPPED WORKING

320

I Have Ford Bantam 1.3i 2007, While Driving The Heater Just Comes On Whethe...

I have Ford Bantam 1.3i 2007, while driving the heater just comes on whether the AC is on or not, causing heat in the vehicle. pls. help

Ford Bantam Bakkie Don't Want To Start

My ford bantam bakkie do not want to start at all. No lights going on as well as the lights on the dashboard. Battery working. No sound when turning the key.

40

I Have Problem I Have Changed Oil Pump But Oil Light Still Flashes And Engi...

bantam rocam engine noise I have replaced oil pump but it has noise when Idling or driving

260

Ford Bantam Starting Problems

Hi! I have a 1.3 bantam 2007 model, it only starts when the engine is cold. Ford mechanic tells me to replace the throttle body, solenoid and the starter motor. Could that be the problem?

Hi ,my Bantam 13 Rocam Has A Computer That Got Wet ,replaced It ,the Bakie ...

Sid van wyk

5

Where Is The PTM Situated On The 2008 Ford Bantam Please?

Ford Bantam Brakes

I wondered if i can change my 2011 bantam disk brakes on my own.will i have to bleed the braking system or can i just remove it and fit the new ones?bcoz if i drive normally i have almost no brake...

30

Please Any Help Will Be Much Appreciated

Please any help will be much appreciated I have a 2010 ford bantam base model. I am struggling to start it in the mornings when its cold. the funny part is the heat gauge always goes to half when I ...

What Type Of Lights Do You Use In The Dashboard?

My dashboard has blown a couple of lights and I'm looking to replace them with LED but no one can tell me what type of pin I need to buy. Any help please?

5

2008 GENERATOR

2008 Ford bantam charging rate varies from 11.5 to occasionally 13 volts. Could this be fault in Generator please?

10

I Have A Ford Bantam 2002 I Cant Seem To Get My Braks Fuction Right Every ...

Ive replaced master celinder brake pads brake discs and fleud please help

30

Hi Guys I Have Ford Bantam Leisure 1600i 2001 Model The Car Uses Too Much P...

Will An Oil Change Cure Timing Chain Rattle

What Are The Torque Specs For 2002 Ford Bantam's Wheel Bearing

10

Tatatata Sound In Engine And Jerking At Certain Speeds

Ford Bantam 1.6ixl 2006 model. Recently overhauled. Running reasonably well before engine overhaul. But now has a serious jerking problem especially at 90kph upwards. secondly, the car has a strange...

Ford Bantam Experts

  • #1
    Guru97FK8
    Reputation
    15,010
  • #2
    Janus Welgemoed
    Reputation
    1,140
  • #3
    MrRocket12
    Reputation
    1,110
View All

Find great deals from top-rated dealers

Search

Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.