Chevrolet C/K 3500 Questions Any type
- Recently Active
Even with brand new battery, battery drains when sitting. Already pulled the ‘courtesy light’ fuse to fix one source. Power door locks work with key fob, but NOT on door switches: could THIS be the...
Can I swap a 1996 extended cab k1500 onto a 1993 k3500 regular cab frame?
The other day I noticed that the indicator light on the dash was flashing fast on the left turn signal. before I had time to check out the bulbs, when i used the signal again both indicators were fl...
i have a 1989 silverado 5.7 liter 4x4 and had my transmission rebuilt. being that my reverse blew up. after having my tranny rebuilt. it only goes from 1st to 2nd and it is overheating. my rebuilder...
I have a 95 Chevy 3500 with the 6.5 diesel. All the sudden I notice that I have no running lights. I have tail lights, headlights, cab lights, cab break light/cargo light, and dash lights. I do n...
Where are all the ground wires located that would have an effect on my problem? Turn ignition on and I have power everywhere, turn key to start and nothing. Not a click, nothing. Has new battery, batt...
Can I take my 2 wheel drive truck motor and transmission and pull the tail shaft off and put the transfer case in for my four-wheel drive 3500
1998 Chevy 3500 van 5.7 vortex put fuel pump but still won't crank
I am attempting to fix my truck. It stalls, and has no power on acceleration. I have changed almost everything except for the ecm computer, the external spark controller and the CRANKSHAFT POSITION SE...
I am looking to have a 3500 chevy shipped from Hastings Colorado to Missoula Montana
I need to find a used light dump truck
can you take out 454 chevy engine and exchange with c/k 1500
We're is fuel pump reset switch
Runs good but under slight deceleration a popping backfire occurs
Will a 1/2 ton rear end bolt right in a 1 ton dually without modification
Okay I have a 1994 chevy Silverado crew cab c3500. I am wanting to buy a 4x4 frame and put my body on it. Do any of you guys know what years would work for this? Thanks
Ok so I bought this 88 Chevy 3500... I had to replace the clutch master cylinder and slave cylinder and am unable to bleed it no matter what I do.. Have tried the , pedal up, open bleed screw, press...
New trans now when i put it in gear it doesnt move unless i give it a little throttle then it jumps in gear
Search Chevrolet C/K 3500 Questions
Chevrolet C/K 3500 Experts
Find great deals from top-rated dealersSearch
Related Models For Sale