Austin-Healey Questions Any type
1960 Austin Healey 3000
A new front headlamp was installed and it works on low beam but goes out completely on high beam. Any suggestions or remedies? Thanks. DanL
Hydraulic Fluid
I have a 67 sprite with the 1275 motor, I replaced the slave cylinder now I need fluid. Should I be using hydraulic fluid like for a jack? I tried power steering fluid but there's no pressure.
Duel Master Cylinder
I want to pull out the old single master cylinder and replace it with a duel unit. Who sells a compatible unit?
BJ8 Quits Running
67 BJ8 that suddenly quits running after fill-up. Replaced most electrical and boiled gas tank. After a few hours, starts again. Any suggestions?
Top Speed
I recently purchased a 68 Healey sprite and was surprised and confused to find it tops out at about 60mph.... and that's red-lined in 4th gear. I am wondering if anyone can tell me what's wrong wi...
How Do You Install Front Brake Shoes On An Austin Healey 100-4?
I was told to attach the spring and then to pry the shoe on. I think this approach is almost impossible due to the strength of the spring. any suggestions? This is a 1953 100-4
How Much Do Fiberglass Fenders Hurt The Value?
I'm looking into purchasing a 1963 3000 mkII,the steel fenders were replaced with fiberglass..all 4. They look great,the only way I could tell was there was no seam under the headlights.The car will b...
Can You Tell Me If This Is A 1962 3000
We found a casting number on the side of the block: AEC 881 We also found a tag on the left side of the engine: 29E/50-H2410 Also, a stamping on the rear end pumpkin: MCWCG. Not to sure about th...
Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.