Asked by cruznbig74 Oct 04, 2019 at 09:52 AM about the 1994 Nissan Pickup 2 Dr XE Standard Cab SB
Question type: Maintenance & Repair
I got no spark coming from my coil. I changed it
out because there was no spark before. How do I
go about looking in to this situation
lincolnscott49 answered 4 years ago
cam sensor controls the coils from the ECM when you turn over the ignition a signal is sent to the ecm from the cam sensor telling the ecm the engine is turning and the ecm sends a signal to the coil. Sounds like a bad Cam sensor and if not problem with ecm
I got no spark coming from my coil. I changed it out because there was no spark before. How do I go about looking in to this situation
1994 Nissan Pickup 2 Dr XE Standard Cab SB
-
Maintenance & Repair
I have no power to ignition coil. Ive checked dudes and all relays in engine bay. I have replaced coil wires cap rotor button still no power to coil. Is there a realy I dont know about.
1990 Nissan Pickup 2 Dr STD Standard Cab SB
-
Maintenance & Repair
I have an 87 D21 Nissan truck it will start and run but just a second then stop firing you can leave it over night and it will crank again. I have changed the coil got the same thing. I checked the vo...
1987 Nissan Pickup
-
Maintenance & Repair
1995 Nissan Pickup 2 Dr XE Standard Cab SB
-
Maintenance & Repair
Pickup at times dies at stop lights/signs or while driving especially going over bumps or ruff roads but not all the time and it started doing this a month ago. Is it the ignition switch or fuel pump?
1995 Nissan Pickup 2 Dr XE 4WD Standard Cab SB
-
Maintenance & Repair
Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.