After replacing brake light switch, brake lights still stay on all the time. What is the next option ??? I just noticed the turn signal arm has to be held down all the time in order for turn signals to flash

140

Asked by bbbendy May 10, 2014 at 08:48 PM about the 1995 Mercury Villager 3 Dr GS Passenger Van

Question type: Maintenance & Repair

I replaced the brake switch, after following the directions, I received from you guys, and the brake lights are still staying on all the time, even with engine off. But I did notice the turn signal arm isn't right. In order for the turn signals to preform properly, you have to hold the arm either; up to turn right or down to turn left ! ! !

199,735

dandyoun answered 9 years ago

Aw now we get all the info. Hard to give good advise without all the info first. Sounds like you have found your problem.

2 people found this helpful.

Mark helpful

Your Answer:

After replacing brake light switch, brake lights still stay on all the time. What is the next option ??? I just noticed the turn signal arm has to be held down all the time in order for turn signals to flash 1 Answer

I replaced the brake switch, after following the directions, I received from you guys, and the brake lights are still staying on all the time, even with engine off. But I did notice the turn signal ar...

1995 Mercury Villager 3 Dr GS Passenger Van

-

Maintenance & Repair
brake light stays on all the time 12 Answers

even with the car not running

1995 Mercury Villager 3 Dr GS Passenger Van

-

Maintenance & Repair
I have a 1999 Mercury Villager that keeps shutting off the battery light stays on along with the brake light but it is a brand new battery. I also have a hole in the tail pipe and it aputters and the the car shuts off. I have changed the fuel filter and the starter 2 Answers

I have a 1999 Mercury Villager that keeps shutting off the battery light stays on along with the brake light but it is a brand new battery. I also have a hole in the tail pipe and it aputters and the ...

1999 Mercury Villager 4 Dr Estate Passenger Van

-

Maintenance & Repair
changed the battery and went to make sure it would start and the check engine light is on any ideas? disconnected the neg. cable first and hooked it up last. 1 Answer

I replaced the battery removed neg. cable first put in the new battery and hooked up neg. cable last. Fired the car up and the check engine light was on and it wasn't on before replacing the battery. ...

1997 Mercury Villager 3 Dr LS Passenger Van

-

Maintenance & Repair
I have 93 villager I've only just got it for my wife two days ago and now I see the speedometer is stuck on 110 all the way to the pin. Is there a way to reset a 93 model villager speedometer 2 Answers

Fuel pump was changed just before we brought the van. Vehicle is like new except for the speedometer.

1993 Mercury Villager 3 Dr GS Cargo Van

-

Maintenance & Repair

Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.