$789.00 to replace a gear shift linkage cable for a 2000 mazda 626 seems awfully expensive. Could this be right

Asked by robyn6860 Oct 23, 2018 at 11:35 AM about the 2000 Mazda 626 LX

Question type: Maintenance & Repair

I had my car towed to a garage and the mechanic has given me an estimate of
$789.00 to replace the gear shift linkage cable in my 2000 mazda 626, which
only has 95,000 miles on it. He said the cable is $190 & its suppose to be a 6.5
hr job. (He looked it up in a labor/procedure manual). Could this be right?

F_O_R answered 5 years ago

Yes it could be right, some jobs are labor intensive. Why not shop around and see what other wrenches charge?

1 people found this helpful.

Mark helpful

Your Answer:

$789.00 to replace a gear shift linkage cable for a 2000 mazda 626 seems awfully expensive. Could this be right 1 Answer

I had my car towed to a garage and the mechanic has given me an estimate of $789.00 to replace the gear shift linkage cable in my 2000 mazda 626, which only has 95,000 miles on it. He said the cabl...

2000 Mazda 626 LX

-

Maintenance & Repair
Can I swap an engine from a 1997 Mazda 626 into a 1999 Mazda 626? 1 Answer

I have a 1999 Mazda 626 that's 2.0L 4 cyl, would it be possible to put an engine from a 1997 Mazda 626 2.0L 4 cyl?

1999 Mazda 626

-

Maintenance & Repair
I need help! I have a 1991 Mazda 626 1 Answer

I need help! I have a 1991 Mazda 626 It has a high idle when it gets warmed up. It runs perfect until then. You can smell gas. But it runs good on the highway. I took it for an emission Test and it fa...

1991 Mazda 626 DX

-

Maintenance & Repair
i have a 2000 mazda 626 lx. the knob to control the temperature swings freely from hot to cold without any form of resistance whatsoever. i assume its supposed to offer some form of resistance it i want to turn it from red(heat) to blue(cold), but it just swings freely. i think something must be broken. i tried to pull it out, but its hopeless. i don't want to break something else. the reason i'm asking this is because my heater is not working and this little problem might or might not be the reason. thanks for your help. 1 Answer

i have a 2000 mazda 626 lx. the knob to control the temperature swings freely from hot to cold without any form of resistance whatsoever. i assume its supposed to offer some form of resistance it i wa...

2000 Mazda 626 LX

-

Maintenance & Repair
Mazda 626 transmission I installed a rebuilt transmission and once completed has loud ticking when I dipped it in gear. What might cause this? 1 Answer

I installed a rebuilt transmission and once completed started car and dropped in gear had loud ticking. What might cause this?

2002 Mazda 626 LX V6

-

Maintenance & Repair

Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.