replacing clutch and can not get the transmission to brake loose

Asked by Jul 19, 2017 at 10:23 PM about the 1994 Jeep Wrangler Sahara

Question type: Maintenance & Repair

1 Answer

107,765

If your sure you have all the bolts out then it is most likely the input shaft is stuck in the pilot bushing, you may have to get two pry bars and start working on alternating pressure on the bell housing to get it out. When you do get it out check the end of the shaft, if it's nicked up some use a good emery cloth to smooth it down before you put in into the new pilot bushing. You can trial,fit on the shaft before the new bushing is installed in the flywheel just too make sure it's smooth enough.

Your Answer

Jeep Wrangler Experts

  • #1
    tennisshoes
    Reputation
    440
  • #2
    Tom Demyan
    Reputation
    430
  • #3
    Mathew Wooldridge
    Reputation
    350
View All

Related Models For Sale

Used Jeep Grand Cherokee
154 Great Deals out of 3,650 listings starting at $2,995
Used Toyota Tacoma
33 Great Deals out of 1,241 listings starting at $4,444
Used Ford F-150
616 Great Deals out of 8,935 listings starting at $1,995
Used Ford Mustang
5 Great Deals out of 1,032 listings starting at $3,995
Used Jeep Cherokee
105 Great Deals out of 7,953 listings starting at $9,950
Used Toyota 4Runner
13 Great Deals out of 525 listings starting at $2,995
Used Chevrolet Camaro
917 listings starting at $11,995
Used Chevrolet Corvette
519 listings starting at $7,900

Used Cars For Sale

2017 Jeep Wrangler Sahara For Sale
108 listings starting at $35,900
2016 Jeep Wrangler Sahara For Sale
3 Great Deals out of 24 listings starting at $31,200
2015 Jeep Wrangler Sahara For Sale
4 Great Deals out of 33 listings starting at $26,998
2014 Jeep Wrangler Sahara For Sale
3 Great Deals out of 28 listings starting at $23,336

Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use.