2003 Jeep Liberty 3.7L V6 Check Engine Light

Asked by Jul 15, 2017 at 06:05 PM about the 2003 Jeep Liberty Renegade

Question type: Maintenance & Repair

I checked the the engine light codes on my 2003 Jeep Liberty 3.7L V6,
because vehicle was jerking, by turning ignition on/off 3 times without
starting and P code 0305 displayed (firing order number 5 was not working
so i took coil off while vehicle was running and no change).  So it had been a
while since I changed all my spark plugs and coils so I did that.  Jeep ran
good for about 100 miles the light came on and vehicle began to jerk again.  
So I took it to Autozone and they asked me did I have the check engine reset
after installing plugs and coils. I said no, so they went out and reset the
engine light and the misfire went away.  So is it standard procedure to reset
check engine light after installing parts causing vehicle to misfire?

6 Answers

My 2003 jeep liberty goes into limp mode after 100 miles as well. It shows a random misfire code but when I restart the car it runs great for another 100 miles. I have replaced the plugs, coils, and Engine control module. It continues to do the same thing goes into limp mode every 100 miles. I am in the process of replacing the 4 oxygen sensors and if that does not work I may replace the full injectors. Any other solutions are greatly appreciated.

Hello Sir, I was wondering if you ever found out the answer or the diagnosis on the situation with your vehicle

Hello Sir, I was wondering if you ever found out the answer or the diagnosis on the situation with your vehicle

I replaced the Sensors on my exhaust and the engine light continues to light up. I am now going to focus on my fuel injectors. The car continues to run great until it goes into limp mode. Then I just turn it off and restart it and it runs great immediately. Any other ideas for a solution would be very helpful and appreciated.

10

Did you ever figure out your problem?

1 people found this helpful.

My 2003 Liberty was doing the same. The shop said it was an exhaust valve and I needed new heads. I used old time cure.I sprayed the intake with water while running the engine.I used about a pint of water in a sprayer. Fixed the problem, been a year no codes run great 226000 miles

Your Answer:

Liberty

Looking for a Used Liberty in your area?

CarGurus has 167 nationwide Liberty listings starting at $5,600.

Postal Code:

Jeep Liberty Experts

  • #1
    fixmyjeep
    Reputation
    1,700
  • #2
    rst429
    Reputation
    1,310
  • #3
    Rowefast
    Reputation
    750
View All

Related Models For Sale

Used Jeep Grand Cherokee
58 Great Deals out of 5,315 listings starting at $1,900
Used Jeep Wrangler
21 Great Deals out of 1,844 listings starting at $3,494
Used Ford Escape
157 Great Deals out of 6,950 listings starting at $1,785
Used Honda CR-V
98 Great Deals out of 4,180 listings starting at $2,995
Used Toyota RAV4
92 Great Deals out of 4,242 listings starting at $958
Used Toyota 4Runner
11 Great Deals out of 509 listings starting at $7,600
Used Ford Explorer
21 Great Deals out of 1,756 listings starting at $2,700
Used Nissan Xterra
4 Great Deals out of 117 listings starting at $2,990

Used Cars For Sale

2012 Jeep Liberty For Sale
8 listings starting at $6,980
2011 Jeep Liberty For Sale
7 listings starting at $6,990
2010 Jeep Liberty For Sale
15 listings starting at $12,630
2009 Jeep Liberty For Sale
14 listings starting at $5,600
2008 Jeep Liberty For Sale
25 listings starting at $6,990

Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use.