the rear end differential is wet , looks like maybe the fluid is leaking from theplate seal. but no noise when in reverse

the rear end differential is wet , looks like maybe the fluid is leaking from theplate seal. but no noise when in reverse 1 Answer

the wheel speed sensor is bad in the rear 1 Answer

dash brake light is on

What is causing stalling and presssure problem when in reverse? 2 Answers

When truck is in reverse, just before it starts to stall, you can feel the brake pedal pushing your foot.

how can a guy replace his rear brake line that starts at the front/Main brake fluid distributor ? , i had to take off complete rear end hose(s) and line(s) because of crack in line above the tire axel 2 Answers

1995 Chevrolet K1500 4X4 A.T. V8 4L60-E ; I have a Brake fluid leak coming from where the Hose meets the 'Brake distributor/Block' where the two wheel lines go that supplies the brake fluid to eac...

1995 Silverado with 5.7 engine. It shows 50 pounds of oil pressure with no oil coming from the push rods. After about 5 minutes the oil begins to seep out. After about 10 minutes oil is oozing from all push rods but does not squirt out. I've seen chevy engines squirt the oil all over the engine bay. Is this a change made for adjusting the valves without using rags to stop the squirting oil? 2 Answers

Found a bad head gasket. When we took the valve covers off and ran the engine, it took 5 minutes to get oil to the rocker arms. After about 10 minutes the oil was oozing out but not squirting. Is this...