Asked by Testarossa_4701 Mar 06, 2017 at 11:39 AM about the 1996 Chevrolet C/K 1500 Silverado Extended Cab Stepside RWD
Question type: Maintenance & Repair
i have changed out the master cylinder, complete front disc brake assembly,and complete rear drum brake assembly, and bled all four lines. pedal still goes almost to floor ,but truck stops a little better.
i have changed out the master cylinder, complete front disc brake assembly,and complete rear drum brake assembly, and bled all four lines. pedal still goes almost to floor ,but truck stops a little be...
1996 Chevrolet C/K 1500 Silverado Extended Cab Stepside RWD
-
Maintenance & Repair
89 chevy 1500 brake lights not working. Flashers, signal, parking lights work and break fuse has power when the key is on. Found that that the brake switch has power when the brake is not being used...
1989 Chevrolet C/K 1500
-
Maintenance & Repair
Ppl say it is my throttle body or my filter on my fuel pump or its I have no back pressure and my o2 senser is messed up since its straight pipe no cat converter. What is it.
1995 Chevrolet C/K 1500 Cheyenne LB RWD
-
Maintenance & Repair
94 Silverado, 5.7 - 350, Starts up fine, idles fine, revs fine in park. Put it in drive and give it gas and it looses power and spits & sputters. It ides a bit rough while sitting there with it in dri...
1994 Chevrolet C/K 1500 Sport Stepside 4WD
-
Maintenance & Repair
My truck puttered then died. At a stop light. Will not start.it tries to turn over. But won't. Won't start . Never had problem before. Never sluggish, never had slow take off prior to it stoppin...
1991 Chevrolet C/K 1500
-
Maintenance & Repair
Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.