throttle body fuel injection repair 84 ford crown vic ltd 302 (5.0)

Asked by Mar 09, 2017 at 02:39 PM about the 1984 Ford LTD Crown Victoria 4 Dr Sedan

Question type: Maintenance & Repair

My throttle body is cracked where the fuel line attachment screws into the throttle body on the inlet pressure side is there a way to seal this crack would hate to have to buy a whole new piece seeing as how it cost more then $500 just to be clear the fuel line and the attachment IS NOT CRACKED the crack is on the throttle body itself

18 Answers


If its not air tight then it will be sucking in air there. What about getting a used on from a junk yard like Pull-a-part they sell parts dirt cheap and just transfer your injectors over to it and this is a good time to do a rebuild, O' rings, filter screens on injectors, fuel regulator ect. you do not need to buy a brand new one they are easy to rebuild or swap parts over to a used housing.


Check youtube for how videos

1 people found this helpful.

Going to check yunkyards on Saturday but have the problem of locating a car as old as mine would u happen to know what cars would be compatible with mine



24,145 does have a remanufactured unit for $302.79 + $50.00 core.


Check craigslist for those models listed above to see if anyone is parting out one of those cars or a to locate a local junk man that has alot of car parts listed, may have it never know.

Also idk if u might know but when cold it starts right up but when warmed up it doesn't want to start


Was this before the throttle body got cracked or what led to the discovery it is cracked?

Before it cracked but after the car sat for about two years

Before the crack but after the car sat for two years

I emptied the tank to put in a new fuel pump about a yeAR ago and never got the time to finish getting it fully back up running but now that I have time it's confusing the hell out of me I just refused the tank flushed the lines which led to the throttle body cracking


Ok when warm hard start up, I find likely causes are loose electrical connections, weak battery or starter, improper ignition timing, Fuel filter, a sticky EGR valve, vacuum leaks, Pumps, sensors, ignition parts, cap, rotor, plug wires, plugs, pick up/stator module, fuel injectors, coils. Although not in this order.

Ok I cleaned out the egr when I had everything apart already have changed fuel filter starter is good changed rotor button and cap redid most of the vacuum system what sensors could I be missing when I go to the junk yard in morning I'm going to try to find good wiring I have a couple of wires that need to be replaced

I know it's not the injectors they are new


Cleaning the throttle body may help, as well as Air Temperature Sensor, Air Charge/Manifold Temperature Sensor, Throttle Position Sensor, Coolant Temperature Sensor, EGR Valve Position Sensor (not Valve), Barometric Pressure Sensor, Crankshaft Position/Angle Sensor & MAF and O2 sensors. Replace the fuel pressure regulator when doing the throttle body this could very well be the issue. There is a test fro EGR valve too. Ignition Pickup/Stator when they go bad most times it will run when cold and will not when warm but with any electrical part it could go bad in a various ways may be worth changing it out. There is some test for almost any sensor with a voltmeter online that would be a good idea to look up some. There is a spring and gasket in the fuel regulator that may when hot not function well or sip out fuel if bad gasket or loose pressure that way too and spring could be bad from being in the same position for a few years along with the crack in casing may be all that is wrong. I would fix those wires too. Check or replace plug & plug wires and use dielectric grease on boots to prevent aching.

Where would the pick up stator be located I don't think this car has temp sensor no gauge on dash and has clutch fan

Gonna see what I can find in junk yard might be able to locate everything for throttle body in better condition then what I have


This answer is likely to late if you left for the junk yard but pick up stator is in the distributor. It just does not have a gauge on the dash.

Your Answer:

LTD Crown Victoria

Looking for a Used LTD Crown Victoria in your area?

CarGurus has thousands of nationwide listings and the tools to find you a great deal.

Postal Code:

Ford LTD Crown Victoria Experts

  • #1
    Tracy Hooks
  • #2
    Michael Tutty
  • #3
View All

Related Models For Sale

Used Ford Crown Victoria
17 listings starting at $8,995
Used Ford Mustang
28 Great Deals out of 1,228 listings starting at $5,995
Used Ford F-150
122 Great Deals out of 11,224 listings starting at $369
Used Chevrolet Camaro
6 Great Deals out of 1,005 listings starting at $4,500
Used Lincoln Town Car
9 listings starting at $6,990
Used Ford F-250
1 listing
Used Dodge Charger
43 Great Deals out of 924 listings starting at $4,490

Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use.