04 Accent Fuel pump relay issues

325

Asked by faaiish Oct 03, 2013 at 01:52 PM about the 2004 Hyundai Accent GL Sedan FWD

Question type: Maintenance & Repair

Last month the fuel pump went bad.  I replaced the fuel pump and found that ECM relay had caused the fuel pump issue (had a windshield leak).  I resealed the windshield and replaced the relay.  The vehicle started and ran like normal once.  I turned the vehicle off and it wouldn't start again.  I checked all the fuses and everything checked out.  I removed the cover to the fuel pump relay and found the relay was not kicking the fuel pump on.  I manually pressed the contacts together and heard the fuel pump running.  Car starts and runs.  If I release the contacts they continue to stay in place and the car will run until turned off.  If you try and restart the car the contacts do not make contact and you manually have to make contact to get it to run.  I checked the pins firing the relay.  I found battery voltage on one side of the fuel pump circuit and the other ohm's out to the fuel pump.  The relay side of the contacts, I have battery voltage on one when the key is turned on and the other side it ohm's .020 to ground when the key is in the on position.  According to the wiring diagram this is correct and I don't see anything causing the relay to not fire correctly.  I replaced the relay with a known good relay and it still doesn't fire.  I pulled the relay up enough I could check the pins on the relay while in the connector and the pins have the same voltage and grounds as before.  I am stumped, the relay by the diagrams I have should be working properly.  The only thing I can think of is the ground on the one side has to much resistance not to fire the relay but if that is what is causing it why would the relay continue to fire only after manually touching the contacts.  The only thing I can think of is the ECM but I hate to waste a couple hundred bucks on a guess.  Anyone have a diagnostic test on the fuel pump relay circuit so I could make sure before buying a new ECM or any idea's on what the problem could be?

1 Answer

325

After checking everything again and still not finding any resistance on the wires from the ECM to the Relay I took the risk. It helped I found a used ECM from E-bay for under $50 bucks. (the dealer wanted $800) I put it in tonight and it fired up without an issue. I take it that the ECM shorted out and did not give the circuit the correct amount of ground for start up.

19 people found this helpful.

Your Answer:

CarGurus Experts

  • #1
    karibt
    Reputation
    2,120
  • #2
    dvigano
    Reputation
    1,860
  • #3
    vasjoker00
    Reputation
    1,760
View All

Find great deals from top-rated dealers

Search

Related Models For Sale

Used Hyundai Elantra
143 Great Deals out of 3,056 listings starting at $3,300
Used Toyota Corolla
137 Great Deals out of 2,258 listings starting at $3,495
Used Honda Civic
190 Great Deals out of 4,208 listings starting at $2,916
Used Toyota Camry
44 Great Deals out of 1,140 listings starting at $3,900
Used Hyundai Sonata
51 Great Deals out of 824 listings starting at $3,995
Used Kia Rio
11 Great Deals out of 190 listings starting at $4,990
Used Mazda MAZDA3
82 Great Deals out of 1,272 listings starting at $2,966
Used Nissan Sentra
63 Great Deals out of 1,899 listings starting at $2,288
Used Hyundai Tucson
93 Great Deals out of 2,515 listings starting at $2,450
Used Honda Accord
59 Great Deals out of 1,026 listings starting at $2,995
Used Honda CR-V
157 Great Deals out of 4,953 listings starting at $440

Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.