My 96 gmc yukon wont move in revearse or park.
Vehicle did not move for 5 years. I bought fixed the
motor(ecm) was bad so i replaced it.went for a test drive
drove great for 4 miles, than stopped at a stop sign and
when i stepped on the gas to go it would not move. Push
home. Waited till it got cold again started it up put it in grar
and still wont move. So please any asistance will help.
It should not move in park as that is mechanical setup. Now as far as the other gears, did you drop the transmission pan before you even started the engine? If not you may have pulled any particulate matter off the bottom of the oil pan and hopefully just plugged up the filter, if it got past the filter then there is a very good chance it fouled up the valve body. If you get that all straightened out then service the differentials and the transfer case. Moisture from just sitting can really do a number on gears and bearings especially after sitting that long. You should probably flush all the fluids, brake, coolant, window washer.
Tennisshoes thankx lotz for your quik responce But im afraid i made myself look stupid its supposed to say drive not park. Im going to change filter and fluid, also will flush out lines acd cooler. I am a great diesel mechanic (big rigs) cat, cummins, detroit and mack even have some mercedes benz knowlege but ive never been good with automatics. Again thanx lotz Guido1125
Hopefully that will get it. If not pull out one quart of trans fluid and add a can of TransX and fire it up and just let it idle for 5 minutes then shut down, do that for a few days and see if it helps clean out all the little passages in the valve body. Good luck
Thanx lotz again most helpful words will let you know when ive got it. And what it exactly took to get it right.
Looking for a Used Yukon in your area?
CarGurus has 1,319 nationwide Yukon listings starting at $2,500.
Search GMC Yukon Questions
GMC Yukon Experts
Find great deals from top-rated dealersTMSearch
Related Models For Sale
Used Cars For Sale