cuts off while filling car up with gas then doesn’t want to start
Asked by Hutson92 Jun 24, 2020 at 01:57 PM about the 2015 Ford Fusion SE
Question type: Maintenance & Repair
I just bought the car and when I go to fill the gas
tank up it dies and doesn’t want to crank back up. I
have to give it a good bit of gas before it will crank
up again for me. Has this happen to anyone else??
5 Answers
Hard start, no start symptoms Right after refueling you may notice extended cranking before firing up or a no start condition. You may also notice a check engine light with trouble codes P1450, P0456 stored in memory. Here’s how to fix the Hard start, no start Escape, Fusion, MKZ Replace the evaporative emission canister purge valve with an updated part. GG9Z-9D289-C Evaporative Emission Canister Purge Valve – Fusion/MKZ 1.5L https://ricksfreeautorepairadvice.com/hard-start-no-start-escape-fusion-mkz/
Hard start, no start symptoms Right after refueling you may notice extended cranking before firing up or a no start condition. You may also notice a check engine light with trouble codes P1450, P0456 stored in memory. Here’s how to fix the Hard start, no start Escape, Fusion, MKZ Replace the evaporative emission canister purge valve with an updated part. GG9Z-9D289-C Evaporative Emission Canister Purge Valve – Fusion/MKZ 1.5L https://ricksfreeautorepairadvice.com/hard-start-no-start-escape-fusion-mkz/
Hard start, no start symptoms Right after refueling you may notice extended cranking before firing up or a no start condition. You may also notice a check engine light with trouble codes P1450, P0456 stored in memory. Here’s how to fix the Hard start, no start Escape, Fusion, MKZ Replace the evaporative emission canister purge valve with an updated part. GG9Z-9D289-C Evaporative Emission Canister Purge Valve – Fusion/MKZ 1.5L https://ricksfreeautorepairadvice.com/hard-start-no-start-escape-fusion-mkz/
Hard start, no start symptoms Right after refueling you may notice extended cranking before firing up or a no start condition. You may also notice a check engine light with trouble codes P1450, P0456 stored in memory. Here’s how to fix the Hard start, no start Escape, Fusion, MKZ Replace the evaporative emission canister purge valve with an updated part. GG9Z-9D289-C Evaporative Emission Canister Purge Valve – Fusion/MKZ 1.5L
Guru95CJL3 answered 3 years ago
I noticed this when I was running a little low on gas and instead of cutting the car off I tried to fillet with the car running and the car cut off then when I tried to start it it took two or three start cycles. I topped it all before leaving South Carolina same thing left a vehicle running and it turned off and took a long time starting so I figured I shouldn’t leave the car running while fueling about halfway back from South Carolina the engine light come on with the above mentioned code When I stopped in Virginia and fueled up I turn the car off and filled it and still had a hard time starting the car afterwards After it starts there’s no problems in between Phillips this just started happening at 83,000 miles and right after both of those trying to start while the vehicle is running
