Asked by Rachel_L7 Mar 28, 2020 at 10:12 AM about the 2015 Ford Fusion SE
Question type: Maintenance & Repair
The car will accelerate fine then once it gets
up to 50 mph it starts to decelerate then it will
slowly get back up to speed again maintain
then start to lose power again. When I shut
the car off it says “hillside assist not available”
never seen that before
A clogged fuel filter can cause this. I would try replacing that first, as it's relatively cheap and usually pretty easy to replace.
Andries003 answered 4 years ago
Rachel did you figure this out? If so and you replaced the fuel filter, where is the filter located?
The car will accelerate fine then once it gets up to 50 mph it starts to decelerate then it will slowly get back up to speed again maintain then start to lose power again. When I shut the car off...
2015 Ford Fusion SE
-
Maintenance & Repair
I just bought my 2010 Fusion SEL V6 and I noticed that the cap can be opened even when locked. Is that normal or is the locking mecanism broken?
2010 Ford Fusion SEL
-
Maintenance & Repair
Can the fuel pump in a 2014 Ford Fusion be accessed without dropping the fuel tank?
2014 Ford Fusion SE
-
Maintenance & Repair
I just need step by step instructions on how to remove and replace my fuel pump on a 2012 ford fusion sel fwd v6 3.0 please and thankyou
2012 Ford Fusion SEL
-
Maintenance & Repair
I'm looking for the location of the fuel filter on my 2013 Titanium Ford Fusion. I'm changing it out but don't want to spend hours looking for it.
2013 Ford Fusion Titanium
-
Maintenance & Repair
Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.