1988 2.8 TBI hard starting after warm. Any way to pinpoint problem.

Asked by bang4dabuck Jun 07, 2015 at 01:12 PM about the 1988 Chevrolet S-10 Blazer STD 4WD

Question type: Maintenance & Repair

Check engine light is NOT on. Replaced intake temperature sender as a guess.  Didn't
do it. Tried spraying engine area looking for vacuum leaks. If I did it correctly, no leaks.

3 Answers

bang4dabuck answered 8 years ago

Just noticed, after I get motor started as I sit in neutral and put the gas pedal to the floor, the engine bogs down a lot. Seems like it is not getting enough fuel or not enough air or ??? Spark plugs/ wires are pretty new. Battery is new too. I do need to change my belt. Is the only way to hook it up to one of those Snap On Tools on board monitors which I don't have ?

Mark helpful

bang4dabuck answered 8 years ago

Changed IAC and cleaned port as well as Temp sensor inside air filter housing was really dirty. It really is having a hard time now when I hit the gas. Doesn't like the stress.

Mark helpful

bang4dabuck answered 8 years ago

Found it runs fine if I don't use the gas pedal to start it. Still having hard time starting after heat soak.

Mark helpful

Your Answer:

Related Questions

  • 1988 2.8 TBI hard starting after warm. Any way to pinpoint problem. 3 Answers

    Check engine light is NOT on. Replaced intake temperature sender as a guess. Didn't do it. Tried spraying engine area looking for vacuum leaks. If I did it correctly, no leaks.

    1988 Chevrolet S-10 Blazer STD 4WD

    -

    Maintenance & Repair

  • can you put an erg valve upside down on 1988 s-10 blazer with 4.3 l engine 4 Answers

    I replaced the ERG valve on a 1988 S-10 Blazer with the 4.3 liter engine. it would barely run after I did this. I took it to a repair shop and they told me I put it on upside down. is this possible ?

    1988 Chevrolet S-10 Blazer Tahoe

    -

    Maintenance & Repair

  • trans clicks when driving any ideas on what i need to do to fix this 2 Answers

    i have an 88 s10 blazer the trabs is leaking a small amount of fluid but the levels show ok when i put it in gear the trans clicks when i am driving is there anyone that has any idea on what this migh...

    1988 Chevrolet S-10 Blazer

    -

    Maintenance & Repair

  • Chevrolet s-10 starting problems 1 Answer

    i have a 1997 chevrolet s-10 4.3, i Change fuel pump, crankshaft sensor, ingnition coil and control module and still dosnt start it will start with starter fluid and then turns off, i need hel asap ...

    Chevrolet S-10 Blazer

    -

    Maintenance & Repair

  • I dont know what kind of Wire harnesses to buy 1 Answer

    I have a 92 st blazer 4 door I want to replace the engine harnesses but dont know the right one to buy any help please

    1992 Chevrolet S-10 Blazer

    -

    Maintenance & Repair

S-10 Blazer

Looking for a Used S-10 Blazer in your area?

CarGurus has thousands of nationwide listings and the tools to find you a great deal.

Postal Code:

Shortcuts

Search Chevrolet S-10 Blazer Questions

CarGurus Experts

  • #1
    Cody Doud
    Reputation
    1,220
  • #2
    Jeremy Roadman
    Reputation
    920
  • #3
    Markfisler
    Reputation
    710
View All

Find great deals from top-rated dealers

Search

Related Models For Sale

Used Chevrolet S-10
2 listings
Used Chevrolet Blazer
18 Great Deals out of 1,138 listings starting at $3,000

Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.