where is the 4 wheel drive module located on my 1988 Ford Bronco 2

Asked by puncho Mar 01, 2015 at 08:15 PM about the 1988 Ford Bronco II Eddie Bauer 4WD

Question type: Maintenance & Repair

My 1988 Ford Bronco 2 will not engage into Four wheel Drive.

1 Answer

239,935

Above the heater box. Every once in awhile the GEM fails but it is not common, the most common failure is the transfer case shift motor, a simple test is to lightly tap on the motor while someone pushes the 4X4 high button, if it shifts into gear then the motor is bad, if not then you need to check the wiring, the first place to check is the section from the shift motor right up to the place where it goes through the floor.

4 people found this helpful.

Your Answer:

Shortcuts

Ford Bronco II Experts

  • #1
    G A Arne
    Reputation
    950
  • #2
    Colin Rivet
    Reputation
    240
  • #3
    Christopher Brownfield
    Reputation
    230
View All

Find great deals from top-rated dealers

Search

Related Models For Sale

Used Ford F-150
98 Great Deals out of 7,077 listings starting at $1,009
Used Jeep Wrangler
18 Great Deals out of 734 listings starting at $8,995
Used Ford Mustang
32 Great Deals out of 1,369 listings starting at $4,900
Used Ford Ranger
9 Great Deals out of 1,530 listings starting at $599
Used Chevrolet Blazer
3 Great Deals out of 865 listings starting at $2,500
Used Chevrolet Corvette
14 Great Deals out of 294 listings starting at $12,900
Used Land Rover Range Rover
9 Great Deals out of 166 listings starting at $8,500
Used Ford F-250
2 listings
Used Jeep Cherokee
54 Great Deals out of 3,853 listings starting at $8,200
Used Toyota 4Runner
11 Great Deals out of 473 listings starting at $11,995

Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.