I don't know what to do motor may be seized please help!

Asked by 89bronco4x4 Apr 21, 2014 at 11:47 PM about the 1989 Ford Bronco XLT 4WD

Question type: Maintenance & Repair

Hey to make a very Long story short I
sunk my bronco in a creek for 2 days
muddin I got it out and it ran like crap
drained the oil, throttle body, air box,
pulled  the plugs and turned the
motor over and got about 4-5 gallons
of water out of it it ran like crap still
with oil preshure all over the place
and leaking a lot of oil everywhere.
So I ended up replacing the oil
pump, oil pan gasket, rear main seal,
trans pan gasket, and a freeze
plug,distributer gasket, button, and
cap. Also I replaced ALL fluids. Well I
got it back up and running but the oil
pressure was below the red line on
Low so we GUESSED it was the
gage that was bad bec It idled so
long without blowing. But anyway we
took it for a test dire with it bein very
slow and wouldn't get out of 1st then
we heard a loud sound and it shut off
never to be turned over again. We
pulled plugs again ( didn't look TOO
bad) tool of starter and surpintine
belt and could barely get it to turn
over by hand ( maybe 1-2
centimeters). I don't know where to
look next ?? It did flash a check
engine before but bec of 89 no obd2
so I'm stuck PLEASE HELP

8 Answers

@beastieboy629 is it possible the torque converter is locked or any other options you can think that I could do becides callin it quits with a seized engine?

39,775

you should never turned it over with water in it, a piston cannot compress water like the air fuel mixture .it will force a head gasket, blow ,a cylinder wall or snap a rod . Easier to drop in a used engine

44,805

Since you use your vehicle like that, you should have a storage unit full of parts, ready to go- engines, trannys, diffs, wheel bearings, electrics- etc.

1 people found this helpful.

Would putting oil down the spark plug hole possible get it move a little more also is it possible it's the torque converter locked up

39,775

apparently ther water got in the oil pan and when turning over the pistons coming down forced water,oil out every escape route, like blowing pan gaskets, up the dist. shaft, and who knows were else, if you herd a crunch it may have seized a piston from silt plugging tiny oil reliefs in crank and piston skirts

2,325

Try Marvel Mystery Oil in each cylinder ....let it set for a day to break the pistons loose

57,935

It's toast. Hydraulic'd and nice and rusty inside by now. Good Boat anchor though.

Your Answer:

Bronco

Looking for a Used Bronco in your area?

CarGurus has 1,993 nationwide Bronco listings starting at $40,999.

Postal Code:

CarGurus Experts

  • #1
    Gene Arnett
    Reputation
    860
  • #2
    Clayton Cameron
    Reputation
    320
  • #3
    Ed92626
    Reputation
    220
View All

Find great deals from top-rated dealers

Search

Related Models For Sale

Used Jeep Wrangler
127 Great Deals out of 5,924 listings starting at $6,500
Used Ford F-150
318 Great Deals out of 13,660 listings starting at $3,800
Used Toyota 4Runner
26 Great Deals out of 540 listings starting at $7,700
Used Ford Mustang
46 Great Deals out of 1,664 listings starting at $5,977
Used Ford Ranger
21 Great Deals out of 687 listings starting at $8,999
Used Land Rover Defender
8 Great Deals out of 296 listings starting at $59,985

Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.