Asked by sgtcolemannathen Jan 27, 2015 at 05:58 PM about the 2003 Ford Crown Victoria Police Interceptor
Question type: Maintenance & Repair
2002 Crown Vic, It will not go into D, 1,2,3, It does however go into reverse. It will idle
down the road but just revs up in drive. Help?
2002 Crown Vic, It will not go into D, 1,2,3, It does however go into reverse. It will idle down the road but just revs up in drive. Help?
2003 Ford Crown Victoria Police Interceptor
-
Maintenance & Repair
My 2006 ford crown vic will not go into drive right away in the morning or when i start it up after sitting a while.. Will take time to go into drive after accelerating ..
2006 Ford Crown Victoria Police Interceptor
-
Maintenance & Repair
I have a 1985 crown vic was working fine but now wont shift .also tried checking fluid level with trans warm in park like the stick askes but fluids all over stick not allowing an accurate reading
1986 Ford Crown Victoria LX
-
Maintenance & Repair
At first, it was idling high when it goes up a hill. Drove it with overdrive off, it run fine. Bought gas, drove, parked for two hour, move it few feet forward and parked. 30 mins later, started it, p...
2009 Ford Crown Victoria Police Interceptor
-
Maintenance & Repair
the first problem clicking was not the temp blend actuator discounted the line to it still had clicking , battery almost dead recharged battery no clicking. good try but nu bull eye thanks. here is a ...
2004 Ford Crown Victoria LX
-
Maintenance & Repair
Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.