I have a 2007 Chevrolet express ... My interment cluster is basically dead ...
Asked by Jayson Apr 06, 2016 at 08:00 AM about the 2007 Chevrolet Express 2500 LS Fleet RWD
Question type: Maintenance & Repair
I have signal flashers and an engine light
on so there is power to cluster .... But
tack,speedo,fuel,voltage are dead ...
I checked all fuses , checked batt ground
and cleaned body ground to batt ... I have
replaced cluster with a known good one
and also tried switching body control
module ... Any help would be awesome
thanks ....
4 Answers
sixfootsix_car_guy answered 8 years ago
The only other issue I can think of would be electrical. As it sounds like you know what you are doing in regards to DIY mechanics, I would probably trace all the electrical lines even back to the ECM. Also I would try clearing all freeze frame and ECM data resetting it to factory spec. Has any other electrical issue cropped up? (Lights? Audio system? Power door/Windows?) The master switch under the hood may also need to be inspected and ensured that its properly grounded. When installing the new cluster did you ensure that the cables that drive the speede/tach are all connected and tensioned properly? I will monitor your post for a reply and hope this helps! Best of luck!
Yes I have diesected plug into back of cluster looks good .... I have not looked at the master switch under hood ?? But all other electrical is working as it should .. And vehicle runs and drives fine ...
sixfootsix_car_guy answered 8 years ago
Check the master switch in the big black box under the hood. Does the van have a security system? Starter Immobilizer?
Ya I'm going to check master switch !! And when I plugged in the used BCM it wouldn't run but I may take to dealer soon to flash BCM .... That may be ...
