migration_judge_roy answered 10 years ago
Bad/corroded ground to chassis...should be brite and shiny with huge amperage capability, also cable from engine to chassis to battery should be clean and free of corrosion, battery should be newer than 7 years old for the amps to be there~...yes undervoltage could cause this~
1990 BMW 3 Series 325is Coupe RWD
-
Maintenance & Repair
1986 BMW 3 Series
-
Maintenance & Repair
I have a 1986 BMW 325 and have replaced the fuel pump, filter, and the starter. It will run for a few days and then not start for a day or two then start again only to not start again! What could be t...
1986 BMW 3 Series 325 Sedan RWD
-
Maintenance & Repair
My vehicle's push start/stop button just stopped working. The car lights and everything come on normally but the car will not crank/turnover. Trying to get some ideas on what the cause is. Saw it co...
BMW 3 Series
-
Maintenance & Repair
The other day I noticed my temp gage started to lean to the red (hot) which it has never done before, but a little while later it was right back dead-center as usual. This morning I started out and in...
2001 BMW 3 Series 325Ci Convertible RWD
-
Maintenance & Repair
Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.