Blower stuck on high

10

Asked by Dec 30, 2016 at 01:02 PM about the 2010 Mercury Mariner Base 4WD

Question type: Maintenance & Repair

I have a 2010 Mercury Mariner the blower is stuck on high. It does not matter if
it is heat or A/C. If you put the selector on high it works on any thing else
nothing. Is this the switch or a relay somewhere else. Thanks.

2 Answers

26,605

That's common when the blower motor resistor pack goes bad. The resistor pack typically sits on top of or adjacent to the blower motor. Cost is around $35 and is an easy DIY job.

1 of 1 people found this helpful.
Best Answer Mark helpful
10

Hey thanks, just bought one on amazon for $14 will fix tomorrow.

Your Answer

Shortcuts

Mercury Mariner Experts

  • #1
    2022erik
    Reputation
    180
  • #2
    Tom Demyan
    Reputation
    170
  • #3
    kbro
    Reputation
    100
View All

Related Models For Sale

Used Ford Escape
201 Great Deals out of 5,623 listings starting at $1,215
Used Ford Explorer
51 Great Deals out of 1,451 listings starting at $2,800
Used Chevrolet Equinox
132 Great Deals out of 5,870 listings starting at $1,400
Used Ford Edge
125 Great Deals out of 2,314 listings starting at $4,800
Used Jeep Grand Cherokee
104 Great Deals out of 2,790 listings starting at $1,500
Used Mazda Tribute
12 Great Deals out of 189 listings starting at $2,500
Used Jeep Liberty
12 Great Deals out of 187 listings starting at $999
Used Honda CR-V
53 Great Deals out of 2,581 listings starting at $1,997
Used Toyota RAV4
53 Great Deals out of 3,209 listings starting at $2,495
Used Honda Pilot
13 Great Deals out of 873 listings starting at $2,950
Used Nissan Murano
78 Great Deals out of 975 listings starting at $1,800
Used Lincoln MKX
21 Great Deals out of 389 listings starting at $5,900

Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use.