Your Answer:
Related Questions
-
the piece of plastic or rubber is missing around my gear shift knob. I donot know what it is called or where to find one exactly. Are they cheap? 1 Answer
2005 Ford Escape XLT FWD
-
Maintenance & Repair
-
My 2008 Ford Escape AWD floor matts keep getting soaked. I thought I had fixed it by making sure the sunroof was closed properly, but it has continued. I have tried to figure out where this is coming from and finally after drying them out again I laid under the the vehicle and both on the drivers side in the middle of the front floor area and the passanger side there is a small hole about the size of a dine right in the middle. That would account for the water coming in after rain storms and such, but why would these two holes be there? Was there a drain area there with plugs and they are missing? Can I have a piece of metal welded over them? Don't know why they would be there. Doesn't seem to be a rust issue as it is frim all around these small holes. 7 Answers
Water leak on floors from underneath. There is a small hole size of a dime on both drivers side and passanger side underneath floor matts right in the middle of each. Can I have this repaired with a...
2008 Ford Escape Limited AWD
-
Maintenance & Repair
-
The light on my clock, gear shift, is out. But after a 5-10 minutes the lights then illuminate. What do I need to replace? Bulb, where us it? 2 Answers
The light on my clock, gear shift, is out. But after a 5-10 minutes the lights then illuminate. What do I need to replace? Bulb, where us it?
2006 Ford Escape XLS FWD
-
Maintenance & Repair
-
What kind of cooling system is my 2003 ford escape V6? Open or closed? 3 Answers
I have an old 2003 Ford Escape V6 engine. My car has been overheating for a few weeks. It was leaking out of the right side of my car by the thermostat. My grandpa has replaced the thermostat (we do...
2003 Ford Escape
-
Maintenance & Repair
-
My 2010 Ford Escape will blow cold air for about 3 seconds when the AC is turned on. I checked the compressor and the clutch will engage for those first couple seconds and then stop completely. I thought it might be low on freon, but when I went to check the low pressure, I got a low pressure reading of 100, which is way too high. My guess is the relay is done or maybe the compressor. Any advice? 1 Answer
My 2010 Ford Escape will blow cold air for about 3 seconds when the AC is turned on. I checked the compressor and the clutch will engage for those first couple seconds and then stop completely. I ...
2010 Ford Escape XLS FWD
-
Maintenance & Repair
Shortcuts
Search Ford Escape Questions
CarGurus Experts
-
#1BrattsReputation4,460
-
#2Gene ArnettReputation3,990
-
#3KenFReputation3,600
Find great deals from top-rated dealers
SearchRelated Models For Sale
Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.