Explorer 2008 Eddie Bauer, 4.0. Problem will not start after a starter change??

30

Asked by klaparhidia Aug 08, 2016 at 10:51 AM about the 2008 Ford Explorer Eddie Bauer

Question type: Maintenance & Repair

Explorer 2008 Eddie Bauer, 4.0. my starter went last week. had car towed to
garage. changed starter. Now starter turns properly however the car will not
run. as if no fuel?? checked pump, relay, fuse,fuel pressure -all ok!! tried a
different key-same thing. Verified the rpm for movement when trying to start
car and it is moving up and down so computer is recognizing... there must be
some type of procedure to follow once battery is disconnected and new
starter is installed?

10 Answers

41,755

Were now at a point of where guessing is of little use for auto service. You confirmed fuel pressure in PSI.. Confirmed rotational speed at crank 200+ with scanner.. computer is displaying all history codes and or freeze frame Data and the vehicle ran perfectly prior to the starter motor being replaced?

30

correct......the last hope of simple solutions is to locate and press the fuel reset button??...any other solutions are welcome...

30

however i am wondering? if fuel pressure is good? then reset button for fuel inertia switch is not relevant?

2 people found this helpful.
41,755

That's correct if fuel pressure is good... forget the inertia switch. have you tried spraying a small amount of starting fluid into the throttle body to make sure the 4.0 has spark plug ignition? also CKP display no codes and will produce a NO start was this disturbed during starter replacement check this My first suspect!

30

where is the crank shaft position sensor located? and how should I proceed to verify the CKP?

1 people found this helpful.
41,755

Basic overview. 1. To test if it your crankshaft position sensor is working properly, you have to test the voltage output. Once that is done, you can compare the readings with manufacturer specifications. 2. Wiring the Multimeter If the voltmeter is equipped with needle probes, the wires at the sensor connector need to be back probed. 3. Set the Multimeter Set a digital multimeter to the AC minivolts range and crank the engine. A normal reading would be 200mV, but again this should be matched with manufacturer specifications. In case the car’s manual states a resistance value, you can check the sensor without having to crank the engine as well. 4. Set the Meter Set the meter to ohms and check the resistance with what is specified in the service manual.

1 people found this helpful.
41,755

Wait did this engine ever run for you? and also you have the correct RFID KEY right? Only three possibilities, Ignition, Fuel, Compression / sealing. Check for spark again and at the right timing interval, confirm fuel pressure and injector pulse at correct time, and that the engine (hardware good valves, etc) can seal the mixture.

30

will go back and verify the spark issue...found one spark plug with a crack, and know ill verify and replace all the others. Key is good, fuel pressure is good, pump is good, relay is good, fuse is good. the last thing i recall is trying to boos the truck not being 100% sure if the starter was at fault and or that a boost may possibly help juice start the truck. I recall some mild smoke from the starter area when i did this?? possible that the computer may need reprogramming if the surcharge may have created a default shut down???

Your Answer:

Explorer

Looking for a Used Explorer in your area?

CarGurus has 2,220 nationwide Explorer listings starting at $7,990.

Postal Code:

CarGurus Experts

  • #1
    OJ
    Reputation
    30,840
  • #2
    TransAm77
    Reputation
    7,790
  • #3
    Gene Arnett
    Reputation
    7,280
View All

Find great deals from top-rated dealers

Search

Related Models For Sale

Used Ford Expedition
19 Great Deals out of 682 listings starting at $5,650
Used Ford F-150
343 Great Deals out of 12,723 listings starting at $599
Used Chevrolet Tahoe
18 Great Deals out of 859 listings starting at $9,980
Used Jeep Grand Cherokee
110 Great Deals out of 3,487 listings starting at $4,950
Used Toyota Highlander
44 Great Deals out of 818 listings starting at $8,495
Used Dodge Durango
70 Great Deals out of 1,993 listings starting at $7,999
Used Ford Edge
88 Great Deals out of 3,491 listings starting at $2,900
Used Honda Pilot
29 Great Deals out of 790 listings starting at $2,495
Used Toyota 4Runner
18 Great Deals out of 514 listings starting at $6,825
Used Chevrolet Traverse
29 Great Deals out of 655 listings starting at $4,995
Used GMC Acadia
25 Great Deals out of 687 listings starting at $4,995
Used GMC Yukon
15 Great Deals out of 936 listings starting at $5,998
Used Ford Escape
157 Great Deals out of 3,950 listings starting at $3,995
Used Nissan Pathfinder
31 Great Deals out of 1,726 listings starting at $285

Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.