Two Intermittent problrms that happen at the same time. Wont come out of park. and AC and heat system stops working

Asked by Cleveland Feb 17, 2016 at 05:45 AM about the 2008 Ford Explorer Eddie Bauer

Question type: Maintenance & Repair

I have checked for power at fuse. it checked good
I have replaced the ignition switch. It still happens.
I have jumped the blower relay.  blower works.
Swapped high relay.  still no change.
At this time the system is not working.
I think it is in the control side.  but not sure where to find wiring diagrams bough a Chilton's  manual. it only had AC system. not much help.

8 Answers

73,250

I believe on your model, the switch on the brake pedal has to work to allow the shifter to be removed from the park position. If you have a bad ground, current will not flow through the "normally off: pedal switch which would allow the shifter to be moved. Same thing happens when a battery is dead, the truck will not come out of park. A bad/loose ground would also explain your other problems which occur at the same time. I suspect one fuse controls the brake switch and instrument cluster.

73,250

Cont.......... When the level will not come out of park, have someone push on the brake while watching the tail lights. If the lights to not come on, the switch could be the problem, but not always. If the lights come on, then you have to check the release solenoid to make sure it is working properly. If you have a center console, it will be located inside, near the shifter. Usually there is a small plastic cover, about one inch square which encloses the manual release on the drivers side of the shift lever up close to the park position.

OJ thank you for the information. The same fuse provides power for both shifter and manual air conditioning control. When it warms up here I will check the fuse and check the brake switch. I believe I am losing power after the fuse and before splits off and goes to each system. I may have to buy a set of wiring schematics.

73,250

The intermittent blowing of a fuse in an automotive environment is caused either by heat or vibration. The bad aspect is usually when the culprit causing the condition is removed, the short no longer exists. The easiest way to go is to start at the fuse block where the fuse blows and follow the load side wire of the fuse looking for damage. This will probably entail removing the wire bundle protector to see individual wires within the bundle. There are short circuit testers available for automotive use which makes this job easier. They cost close to a hundred bucks each, and are good at finding continuous short. But the short must be active when test is performed.

73,250

You indicated the only two components affected are the AC and shift interlock. Disconnect all power from the AC controls and see if the problem with blowing the fuse goes away. If it does, then we know which system is affected. If it still persist, disconnect the shift lock system and see if the problem is solved. There should be a manual button you can push to unlock the shifter so the vehicle can be placed in gear. Keep in mind the short will be on the load side of the fuse, and before the resistance item the fuse operates, be it a fan motor, light bulb, ect.

I found it. The fuse receptacle had been spread out from having a after market DVD installed when we purchased the Explorer. They had added a additional peace of metal to the fuse receptacle . I had problems with the DVD player and had changed the power source about three years ago. The fuse was not blown and I had power. I could simply touch the fuse and the blower would turn on and off. OJ. Thank you very much for taking the time to help. So for now I have put a (S) bend in the fuse terminals to make better connections. It looks like I would have to remove the hole fuse panel to squeeze the receptacle so it would apply more pressure on the fuse terminals.

73,250

You have a couple of alternatives here. 1.) If you have an unused terminal in the fuse box, you can use that after redirecting the load side of the affected terminal to the new location. Or you can purchase an inline fuse holder and redirect the line and load ends of the connection to that. Good Luck.

Your Answer:

Explorer

Looking for a Used Explorer in your area?

CarGurus has 2,220 nationwide Explorer listings starting at $7,990.

Postal Code:

CarGurus Experts

  • #1
    OJ
    Reputation
    30,840
  • #2
    TransAm77
    Reputation
    7,790
  • #3
    Gene Arnett
    Reputation
    7,280
View All

Find great deals from top-rated dealers

Search

Related Models For Sale

Used Ford Expedition
19 Great Deals out of 682 listings starting at $5,650
Used Ford F-150
343 Great Deals out of 12,723 listings starting at $599
Used Chevrolet Tahoe
18 Great Deals out of 859 listings starting at $9,980
Used Jeep Grand Cherokee
110 Great Deals out of 3,487 listings starting at $4,950
Used Toyota Highlander
44 Great Deals out of 818 listings starting at $8,495
Used Dodge Durango
70 Great Deals out of 1,993 listings starting at $7,999
Used Ford Edge
88 Great Deals out of 3,491 listings starting at $2,900
Used Honda Pilot
29 Great Deals out of 790 listings starting at $2,495
Used Toyota 4Runner
18 Great Deals out of 514 listings starting at $6,825
Used Chevrolet Traverse
29 Great Deals out of 655 listings starting at $4,995
Used GMC Acadia
25 Great Deals out of 687 listings starting at $4,995
Used GMC Yukon
15 Great Deals out of 936 listings starting at $5,998
Used Ford Escape
157 Great Deals out of 3,950 listings starting at $3,995
Used Nissan Pathfinder
31 Great Deals out of 1,726 listings starting at $285

Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.