Dash just went out, no turn signal no hazzards no miles no speed etc....

Asked by williamsfamily2012 Jun 12, 2012 at 07:08 AM about the 2007 Chrysler Town & Country Touring LWB FWD

Question type: Maintenance & Repair

Driving and dash went out, no signals no hazzards no miles no speed.......cluster completely out on 2007 town and country that is well kept....only has 52, 000 on vehicle......any ideas????? Need help unsafe to drive

13 Answers

300

Check the hazard lamp fuse (20a) in the fuse box by the battery. Mine was blown, replaced and everything back to normal. Thanks internet!

30 people found this helpful.
850

tried fuses still no miles or turn signals no hazards no ding when door is open need help bad

85 people found this helpful.
90

Pheasent brother, you saved my vacation. Thank you.

9 people found this helpful.
110

2002 T&C 68k orginal miles: Remove battery, flip fuse box over to left side pry outward on large flat tab right side. Carefully unplugged all connectors 1 at a time cleaning contacts with brake parts cleaner or some kind of contacts cleaner. Unscrew flasher module front of fuse box (5 Torques screws) carefully wiggle module side to side pulling out ward or pry behind flasher module with flat tip screw driver while pulling outward & gentle wiggle. Clean all contacts & replace module and torques screws. Carefully flip fuse box tucking connectors under it pressing down until it locks, replace battery. EM flashers work again and turn signal doesn't fault the instrument panel BCM computer on fire wall under dashboard.

11 people found this helpful.
210

I had this problem and it turned out to be a wire had come loose from the positive battery terminal. Aside from the obvious large cable on the positive side there was also a small wire that plugged into a small connector coming off of the positive terminal. It had worked loose from the small connector. As soon as I reconnected it the instrument cluster and turn signals all worked as they should.

21 people found this helpful.
130

Had this exact problem suddenly after after installing a new battery, disappointing and baffling. Everything worked but no gauge cluster lights or gauge functions. Oddly the backlit needles of the gauges *did* work. No other lights in cluster. All needles at zero. No odometer. Turn signals and *hazards* didn't work either, and high beams worked but would not stay on. All other exterior lights were normal. Other dash lights and interior lights normal. Could not "reset" gauge cluster (you cannot reset a gauge cluster unless it has power). Checked the notorious "hazard" light fuse, and the notorious "small red wire" from the battery, and it turns out the electrical flat connector bolted through on the positive terminal was naturally just corroded enough to insulate it even when bolted up tight. Impossible to notice this. Taking it apart they seemed soldered together but they were only fused by oxide. Knock them apart and scrape and wire brush everything. Fixed problem instantly. Chrysler likes to bolt little wires to the battery. There is another wire bolted at the negative terminal. This is poor design that looks like wiring as an afterthought or a kludgey modification.

13 people found this helpful.
30

Did u fix it. What did u do to fix it. I've got same issues

3 people found this helpful.
90

My 2002 Town and Country had the dash gauges and signal go out and all it turned out to be was a separate red wire connected to the positive battery terminal. It had corrosion on it and I cleaned it up with sand paper.

9 people found this helpful.
70

My 2009 has the same issue. I am going to try all of these answers and let you know.

7 people found this helpful.
50

It's the same positive terminal screw tht bolts in, I replaced my battery and same prob. No guages, no od, no gas gauge, all backlit, no turn signals It was because I didn't screw the positive back in which is connected through a red circle hole tht is attacheD to a red wire

5 people found this helpful.
30

Mine was the fuse to the Hazard lights 20 amp. Took some thinking and testing. I used a volt meter and checked both sides of all fuses with engine running.

3 people found this helpful.

Your Answer:

Town & Country

Looking for a Used Town & Country in your area?

CarGurus has 123 nationwide Town & Country listings starting at $3,207.

Postal Code:

CarGurus Experts

  • #1
    Lisa Klancher
    Reputation
    3,570
  • #2
    dandyoun
    Reputation
    3,280
  • #3
    thejeepdoctor
    Reputation
    3,160
View All

Find great deals from top-rated dealers

Search

Related Models For Sale

Used Dodge Grand Caravan
90 Great Deals out of 1,866 listings starting at $2,495
Used Chrysler Pacifica
46 Great Deals out of 794 listings starting at $15,900
Used Honda Odyssey
44 Great Deals out of 802 listings starting at $2,900
Used Toyota Sienna
36 Great Deals out of 578 listings starting at $2,499
Used Ford Expedition
18 Great Deals out of 682 listings starting at $5,650
Used Chevrolet Equinox
103 Great Deals out of 3,646 listings starting at $1,995
Used Chevrolet Suburban
16 Great Deals out of 511 listings starting at $11,950
Used Chevrolet Tahoe
18 Great Deals out of 859 listings starting at $9,980
Used Ford Explorer
53 Great Deals out of 2,231 listings starting at $7,990
Used Ford F-150
363 Great Deals out of 12,802 listings starting at $599
Used Toyota Highlander
37 Great Deals out of 814 listings starting at $8,495
Used Chevrolet Silverado 1500
222 Great Deals out of 9,112 listings starting at $2,900
Used Honda Accord
59 Great Deals out of 1,026 listings starting at $2,995

Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.