Hi, I have a 2007 Jeep compass 2.4 77,000 on it. I received a code P2004 and then replaced the Intake manifold Runner Control Valve. after doing so, more codes came up: P2004 (intake manifold runner control stuck open bank 1), P2017 (intake manifold runner position sensor/switch circuit high bank 1), P2016 (intake manifold runner position sensor/switch circuit low bank 1) and then P2004 (again, on same scan).any suggestions?Thanks!

I would send some fuel treatment through the engine and i know this is crazy but clean the flutter valves on the intake and the intake with carb cleaner and see if that helps

Also check to see if its warpped the intake that is if so you can get a new one for $134

When I bought it last week, I put some fuel treatment through it and carb cleaner through the throttle body. I haven't been able to find any instructions to take off the manifold - how difficult it is or can i reach the flutter valves without taking it off?