I have a 2005 Ram 1500 ST. Putting a cb radio. Will have to floor mount with self tapping screws. Is the floor thick enough to use screws WITHOUT them going all the way through to the outside?

Asked by bigjohn1962 Mar 12, 2013 at 03:56 PM about the 2005 Dodge RAM 1500 ST RWD

Question type: Car Customization

I have a 2005 Ram 1500 ST. Putting a cb radio. Will have to floor mount with self tapping screws. Is the floor
thick enough to use screws WITHOUT them going all the way through to the outside?

175,945

tenspeed answered 11 years ago

No, the floor is not thick at all. It's about as thick as a cereal box. Look underneath to see if you would be making holes in any of the brake lines, fuel lines or electrical cables before preceding.

1 people found this helpful.

Mark helpful

85

reitz answered 11 years ago

No the floor is not thick enough, but there are certain areas that are covered by chassis where your screws might not be visible from below and remain hidden, but once you take off your CB in future you will end up seeing these holes.

1 people found this helpful.

Mark helpful

bigjohn1962 answered 11 years ago

Thanks guys! I guess I need to find an alternative place to mount it...lol. Thanks!

Mark helpful

175,945

tenspeed answered 11 years ago

You could use the 'hook' part of velcro and that should grip the rug with no holes.

1 people found this helpful.

Mark helpful

bigjohn1962 answered 11 years ago

I'll keep that in mind. Never thought of it. Thanks. Also found a mount I'm thinking about. Here it is anyone else is looking an alternative. It sits on the carpet and has teeth that are supposed to stabilize it. It comes in two halves so it will fit any size cb: JB-PJBC-1000 Hump Mount Thanks again!

Mark helpful

40

Ken answered 6 years ago

I have a Uniden Grant CB and how I did it was take couple pieces of 2x4. Put one flat on floor and see how it 'Wedges" Under the middle of the seats between seat frame and transmission tunnel. If it wedges in snuggly like mine did then take it out and nail or screw a vertical piece of 2x4 that comes up to just below the top of the seat. Screw your CB Bracket to that 2x4 and mount your radio Faceplate towards the roof. Coaxial cable and power cords just above the floor.

Mark helpful

Your Answer:

I have a 2005 Ram 1500 ST. Putting a cb radio. Will have to floor mount with self tapping screws. Is the floor thick enough to use screws WITHOUT them going all the way through to the outside? 6 Answers

I have a 2005 Ram 1500 ST. Putting a cb radio. Will have to floor mount with self tapping screws. Is the floor thick enough to use screws WITHOUT them going all the way through to the outside?

2005 Dodge RAM 1500 ST RWD

-

Car Customization
I was putting a new radio into my 03 Ram 1500 and just to make sure the radio worked in it.I must have not protected a couple of the wires all the way and a couple of the wires touched on the back of the radio. after the fact, the courtesy light wont come on when opening the door, and Pretty much all the functions that a vehicle is supposed to perform without turning on the vehicle don't work. and neither does the radio when I hook it up. Yes, i checked all the fuses in my fuse box. I even wen to the point of replacing all of the, even the ones that i thought had nothing to do with the situation. the radio still works because i checked it by putting power to it by directly putting it to the battery. and the fuse didn't pop in the back of the radio when all this happened. so at this point I'm completely lost. Any help with this would be much appreciated. 1 Answer

Putting in a new radio, a hot touched something and now nothing works.

2003 Dodge RAM 1500 ST RWD

-

Car Customization
i'm building a 1996 dodge ram 1500 360c.i. can you reflash the computer to take all the upgrades i'm putting in it 2 Answers

I'm putting a bigger cam, bigger heads, roller rockers, more compression and redoing the bottom end with better crank and keith black pistons.

1996 Dodge RAM 1500

-

Car Customization
Whats the biggest tire I can put on a stock 2001 Dodge Ram Laramie 1500 SLT? Im willing to use spacers. 2 Answers

Whats the biggest tire I can put on a stock 2001 Dodge Ram Laramie 1500 SLT? Im willing to use spacers. Currently has a 265/75/16

2001 Dodge RAM 1500 SLT Plus Quad Cab 4WD

-

Car Customization
I am wanting to replace the 4.7L Magnum in my 2004 Ram 1500 VIN N with a performance engine. I am not looking to race. I also want something that will install with as little mod as possible. Ideas? 9 Answers

My plan is to install the new motor and then add a performance intake and flowmaster dual exhaust. I want that throaty growl when i get on it.

2004 Dodge RAM 1500 Laramie Quad Cab RWD

-

Car Customization

RAM 1500

Looking for a Used RAM 1500 in your area?

CarGurus has 95 nationwide RAM 1500 listings starting at $5,999.

Used Ford F-150

336 Great Deals out of 13,399 listings starting at $3,000

Used Chevrolet Silverado 1500

201 Great Deals out of 8,235 listings starting at $6,995

Used GMC Sierra 1500

141 Great Deals out of 8,345 listings starting at $5,975

Used Dodge RAM 2500

27 listings starting at $9,900

Used Toyota Tundra

29 Great Deals out of 988 listings starting at $10,698

Used Dodge Charger

32 Great Deals out of 909 listings starting at $5,495

Used Toyota Tacoma

30 Great Deals out of 723 listings starting at $9,975

Used Jeep Grand Cherokee

115 Great Deals out of 3,522 listings starting at $4,950

Used Dodge Durango

51 Great Deals out of 1,890 listings starting at $6,987

Used Chevrolet Silverado 2500HD

29 Great Deals out of 1,717 listings starting at $8,999

Used Ford Mustang

51 Great Deals out of 1,662 listings starting at $5,977

Used Jeep Wrangler

125 Great Deals out of 5,974 listings starting at $8,990

Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.