Why do both lights stay on when the 4 wheel drive is engaged? sometimes it does not go in the lights

35

Asked by tbalas1 Mar 09, 2008 at 10:07 AM about the 1994 Chevrolet S-10 Blazer 4 Dr Tahoe 4WD SUV

Question type: Maintenance & Repair

When I try to put the 4 wheel drive the switch will blink. then both lights will stay on and i don't know if its in high or low 4 wheel drive. some times it just blinks and does not engage at all. whY?

2 Answers

83,745

Sounds like the vacuum/electrical switch that kicks over the 4WD is going out. I would take this to a mechanic and have it checked out. It's not a hard or expensive fix but it could be either wiring related or switch related.

2 people found this helpful.
1,275

this propblem can be caused by 1 the encoder motor/transfercase motor 2 the transfercase switch 3 vaccum actuator under battery tray 4 broken cable from actuator to front diff. now we know the possible problems lets check them individualy fist the encoder motor when your in nutral and press the 4hi button does it flash and just never go in? can you hear an electric motor? after you press 4hi get undernieth the blazer and check if you can turn the front drive shaft by hand? in not this is a good thing and means your transfercase is locked in four wheel drive. if you can turn the drive shaft by hand i would replace the encodermotor (any where from 130$-150$ at a parts store and you do the work your self second is testing the vaccum lines after your transfer case is locked there is one line going from the back of the plenium to the switch on top of the transfercase when the engine is running it should have vaccum when you put it in 4hi it switches the switch and provides vaccum to the front actuator under the batery tray (this is the hose i think one of the privious posters talked about) make sure there is vaccum to the hose when in four wheel drive and if there is no vaccum i would replace the vaccum switch (10$-20$ at parts store and you do the work your self) if there is vaccum then you need to test the actuator it self you should be able to see it move when 4wheel drive is turnd on and off if it dont move the diphram could be tore and if it does move then very very very unliky your cable from the actuator to the front differntial is broken and i dont know what would be wrong hope this helps let us know when/if you fix it *the picture is of the actuator under the tray p.s dont listen to the post before me i would fix it myself if i was you

3 people found this helpful.

Your Answer:

CarGurus Experts

  • #1
    Cody Doud
    Reputation
    1,220
  • #2
    Jeremy Roadman
    Reputation
    920
  • #3
    Markfisler
    Reputation
    710
View All

Find great deals from top-rated dealers

Search

Related Models For Sale

Used Chevrolet S-10
2 listings
Used Chevrolet Blazer
20 Great Deals out of 1,222 listings starting at $22,880
Used Chevrolet Tahoe
12 Great Deals out of 841 listings starting at $698

Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.