Idles fine but dies when given gas

I've also replaces iac tps is working hooked up to scaner and everything is reading good all o2s are working i dont understand

How about the throttle positioning sensor

Torque converter stuck? And scan for codes.

I have scanned the truck and no codes disconnected the mass air flow truck idles fine I've replace the intake manifold gasket throttle body gasket spider injectors gasket I don't think it's vacuum cuz I don't hear any sucking or what would sound like air leaking

When I do a livestream on my scanner I mean legitimately everything is working completely fine throttle positioning sensor is on point O2 sensors are working fuel system is working mass air flow is reading correct the map is reading correct I'm at a complete loss I'm starting to think maybe it might be the computer now I will say my coil plug wire is arcing off of my transmission dipstick

Hornet if the torque converter is locking up would it die automatically when you put it in Drive and not in reverse because when I put it in drive it dies when I put it in reverse it stays idling but it's wants to hesitate to die

Check for a blown ( ETCS ) Electric Throttle Control System fuse.

The reason I disregarded it dying in drive, while not dying immediately in reverse, is because reverse is geared lower and more likely to move than to die with a locked torque converter. But that's a subtle difference most would not know or think of. So let us know what you find.