four wheel drive
Asked by greasemonkey911 Jan 19, 2014 at 07:52 PM about the 1994 Ford F-150 XLT 4WD Extended Cab LB
Question type: Maintenance & Repair
four wheel light switch is always on and wont go into four wheel it has a new switch, new transfer case shifting motor and modrole am I missing anything
4 Answers
It sounds as if you have a vacuum solenoid problem. The 4x4/4x2 vacuum solenoids are attached to the upper RH side of the engine compartment, and alternately route vacuum to the vacuum motor which engages/disengages the center axle disconnect collar in the front axle assembly.They are grounded when activated, open circuit when deactivated.I would first of all make sure that you have power to them on the W/LB wire with ignition in run postion.If not then check fuse 23 (10amp) in the interior fuse panel.Disconnect the solenoids and measure their resitance should be between 50-100 ohms
If yours does not have the vacuum set up you have a bad new transfer case motor.
It sounds like my four-wheel drives trying to kick in going down the highway it's grinding sounds like it's Gears of trying to go into gear
It sounds like my four-wheel drives trying to kick in going down the highway it's grinding sounds like it it's trying to engage. It's a F150 2012 4 wheel drive