welded a braket on my chevy tracker and now it wont start

Asked by oldman045 Sep 09, 2017 at 06:58 PM about the 2003 Chevrolet Tracker 4-Door 4WD

Question type: Maintenance & Repair

it rolls over just fine and everything works lights,radio,blower motor. but it wont start. cant here the feul pump and i pulled the bolt out of the feul rail and get no feul. changed the feul pump relay and still nothing.

2 Answers

216,045

Check the fuel pump fuse and also for any blown fuses. So I am going to assume you used an arc welder, so did you disconnect the battery before welding on the bracket? If not, some of the systems are still in KAM mode and an arc welder can damage those systems. You may have more problems after you get the fuel pump running. Try this: spray a little starting fluid down the intake while cranking, if it fire and runs even briefly then it is fuel, if it doesn't fire it is spark.

used a mig welder. all i did was tack it in place.i checked the pump fuse and it was good. thank you and if you have any other ideas please let me know. im going to try the starting fluid now.

Your Answer:

Chevrolet Tracker Experts

  • #1
    actuatorfix
    Reputation
    1,240
  • #2
    theta
    Reputation
    410
  • #3
    Charlotte Francis
    Reputation
    380
View All

Find great deals from top-rated dealers

Search

Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.