my 2003 grand am cant get no brakes tryed to bleed them wont work but there is brake only when i put her in netural but in drive and reverse brake goes to floor

Asked by May 10, 2017 at 07:33 AM about the 2003 Pontiac Grand Am SE2

Question type: General

2 Answers

75,605

If the master cylinder went dry on brake fluid, then air is trapped in the ABS control module, and a shop would have to bleed the air out since it takes a computer to do this. Otherwise it could be the master cylinder is bad.

1 of 1 people found this helpful.
104,405

Try bleeding the brakes with the key on, then look on the ABS unit and see if there are any bleed screws on it, if so bleed those first, and then start with the bleeder the farthest away from the master cylinder, usually the right rear, then left rear, then right front and finally left front.

1 of 1 people found this helpful.

Your Answer

Pontiac Grand Am Experts

  • #1
    tenspeed
    Reputation
    7,890
  • #2
    John Saffrahn
    Reputation
    1,610
  • #3
    Tom Demyan
    Reputation
    1,580
View All

Related Models For Sale

Used Pontiac Grand Prix
6 Great Deals out of 72 listings starting at $1,600
Used Pontiac Firebird
17 listings starting at $8,700
Used Chevrolet Camaro
917 listings starting at $12,000
Used Chevrolet Impala
113 Great Deals out of 1,116 listings starting at $996
Used Pontiac GTO
4 listings starting at $13,900
Used Ford Mustang
14 Great Deals out of 1,156 listings starting at $4,500
Used Toyota Camry
108 Great Deals out of 2,542 listings starting at $2,000
Used Honda Accord
89 Great Deals out of 1,119 listings starting at $750
Used Honda Civic
347 Great Deals out of 3,896 listings starting at $1,495
Used Ford F-150
656 Great Deals out of 13,620 listings starting at $3,000
Used Chevrolet Monte Carlo
17 listings starting at $2,188

Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use.