my top won't go all the way down. What can I do?

Asked by prevjp Jul 15, 2013 at 12:14 PM about the 1997 Audi Cabriolet FWD

Question type: General

do I have oil any lines etc.

5 Answers

take a shopvac with the small tip and suck up any spiders, leaves, dendrites....dirt, sand spores anything that would stop full motion~ lubricate the joints with tri-flo....just a few drops, that stuff goes everywhere~

2 people found this helpful.

Agreed. Foreign objects in mechanism or stow compartment maybe

1 people found this helpful.

Hello , Audi top stuck , try this with the ignition on cycle manually the entire system , but in the process look at the right rear section where the top will tuck in , look carefully you will see 3 sensors check them make sure they move freely and not stuck , then most mportant check rear seat belt make sure they are fully retracted and the red securment button is not stuck in other words make sure all rear seat belts are in correct position , then put in back to normal position , turn off switch , also make sure your two fuses are good , then lock the system manually , then once again cycle the system entirely all the way do not move any sensors or you will fool the computer , cycle the top all the way turn off your ignition and try it , if still does not work then recheck the side sensors , they are not too difficult , good luck

Your Answer:

Cabriolet

Looking for a Used Cabriolet in your area?

CarGurus has thousands of nationwide listings and the tools to find you a great deal.

Postal Code:

CarGurus Experts

  • #1
    LTW
    Reputation
    150
  • #2
    Shawn Fisher
    Reputation
    90
  • #3
    pareif
    Reputation
    70
View All

Find great deals from top-rated dealers

Search

Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.