My radiator hose had a hole and wet the wire

Asked by Tata2003 Dec 30, 2017 at 12:35 PM about the 1993 GMC Sierra 1500 C1500 SLE Standard Cab LB

Question type: Maintenance & Repair

I have a 93 and I put fuse in and blow right after I
turn my light switch on is there suppose to be a
black tar substance on were all wire connect on
fire wall

101,515

KenF answered 6 years ago

There should be a grommet of some sort to protect wires through the firewall. Check all harness connector ends too, that they're not pulled out/stretched wires, and no frayed wiring anywhere. Obviously you know the circuit that is affected since it keeps blowing the fuse. Most parts places have assorted grommets. IMO Napa has the best selection of items like that.

Mark helpful

Your Answer:

My radiator hose had a hole and wet the wire 1 Answer

I have a 93 and I put fuse in and blow right after I turn my light switch on is there suppose to be a black tar substance on were all wire connect on fire wall

1993 GMC Sierra 1500 C1500 SLE Standard Cab LB

-

Maintenance & Repair
how do you cover the hole thats on the side seat belt panel that bolts to the body? 5 Answers

I just removed the seat belts in my 1994 sieerra 1500 and the hole where the seat belt that conects to the cars body by your head is pretty big and anoying and i was wondering what and how do you fi...

1994 GMC Sierra 1500 C1500 SLE Extended Cab SB

-

Maintenance & Repair
I have a 2016 Sierra SLE I came out and started my truck had been driving it that morning it was fine. I come out the store I started my check engine light is on and it would not go in drive. 8 Answers

I started my truck drove it fine earlier came out store i started it my check engine light come on and my truck will not wouldn't move when I put it in drive. everything was good earlier when I drov...

2016 GMC Sierra 1500 SLE

-

Maintenance & Repair
After doing a brake job and hooking up the brake sensor wire my dash brake light remains on. How do I get this light out there is nothing wrong with my brakes? 1 Answer

I had to disconnect the brake sensor wire while changing a wheel bearing and front brakes on my GMC 07 Truck. I used a C clamp to push in the caliper now after connecting brake sensor wire I now have...

2007 GMC Sierra 1500 SLE1 4WD

-

Maintenance & Repair
What is causing my GMC to advance the timing about 25° when I plug the wire under the dash together? 1 Answer

I disconnected the tan/black wire before setting the timing. I set the timing to 0°. Shut it down, connect the wire back, and when I check the timing, it advances about 20°. If I disconnect the wire...

1995 GMC Sierra 1500 C1500 SL Extended Cab SB

-

Maintenance & Repair

Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.