Why no fire from the coil?!?!

what is a spout connector ?????????

ok found that gray connector ..4 or 5 wires going into the dist ...just didnt know it was called that ...

im going through the same thing with my 1990 ford ranger ,,everything new and no spark ..

what happens with mine is ,, i turn the key on ,,one spark ,, i crank it and it sparks like 3 more times and its done ..no more spark til i shut the key off and do the same thing ..one spark ,,then 3 sparks then none at all ...

also mine doesnt start when that spout is disconnected ..just as i said in my last comment

the distributor i installed was a new one ..i have a bad eec relay ,,im going to replace that today ,,will let you know if that was the problem or not ... thanks ken

Mine did that and I cleaned the ground on the side of coil and it started sparking right.

Crankshaft sensor replace it $150without a good one you will be waiting for AAA on the side of freeway. No spark will happen and no signal to fuel injection. Should start right up after you replace

I changed every thing and still no fire from coil changed distributor and all

Caught a pothole on my 1997 3.0 Ford Ranger and mile 1/2 later it shut down on me. No spark on coil. had coil replace and crank sensor still no spark. What other thing could cause no spark ?

what did Roland do to fix the truck my email is michaelbogan1@comcast.net

Got fire from the coil but the rotor turns real slow. What would cause this?