is there a test that you can do to see if the water sensor is bad that goes to the computer on a 93 ford ranger 3.0

Asked by Ithol Oct 29, 2013 at 10:48 PM about the 1993 Ford Ranger XL Standard Cab LB

Question type: Maintenance & Repair

i got a bad low speed miss and waqs wondering is i could test the water temp sensor.

migration_judge_roy answered 10 years ago

Unplug the harness connector. First, check the signal voltage at the connector with the key on, engine off. Should be approximately 5.0v. Then, check the resistance of the sensor cold. Should be between 58,750 to 40,500 ohms. Plug in the harness connector and warm up the engine to normal operating temperature. Then, unplug and check the resistance of the sensor hot. Should be 3,600 to 1,840 ohms.

2 people found this helpful.

Best Answer Mark helpful

Your Answer:

Used Ford F-150

336 Great Deals out of 13,399 listings starting at $3,000

Used Jeep Wrangler

125 Great Deals out of 5,974 listings starting at $8,990

Used Ford Mustang

51 Great Deals out of 1,662 listings starting at $5,977

Used GMC Sierra 1500

141 Great Deals out of 8,345 listings starting at $5,975

Used Toyota 4Runner

27 Great Deals out of 530 listings starting at $7,990

Used Dodge RAM 1500

95 listings starting at $5,999

Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.

is there a test that you can do to see if the water sensor is bad that goes to the computer on a 93 ford ranger 3.0

1 Answer

Your Answer:

Shortcuts

Search Ford Ranger Questions

CarGurus Experts

Find great deals from top-rated dealers

Related Models For Sale

is there a test that you can do to see if the water sensor is bad that goes to the computer on a 93 ford ranger 3.0

1 Answer

Your Answer:

Related Questions