Should put new lifters and push rods?
On my chevy silverado i took off the intake
manifold to repalce a gasket and thought if i
should change mu lifters and push rods now that i
have evering apart
On my chevy silverado i took off the intake manifold to repalce a gasket and thought if i should change mu lifters and push rods now that i have evering apart
2000 Chevrolet Silverado 1500 RWD
-
Maintenance & Repair
Do you change the oil and put the Blue Devil in!
2000 Chevrolet Silverado 1500 LB RWD
-
Maintenance & Repair
Have put new wires and plugs fuel pressure at fuel arm is 50psi when key is on and 55 if engine is turned over but won't run . Pump , regulator mass air flow sensor what and how to troubleshoot
2001 Chevrolet Silverado 1500 LS Extended Cab RWD
-
Maintenance & Repair
Even though the light on the dash says it is 4 high or 4 lo, the front end is engaging. I just spin the back tires on snow. I read that I should replace the front axle actuator, so I did that and st...
2005 Chevrolet Silverado 1500 Z71 Extended Cab 4WD
-
Maintenance & Repair
1994 Chevy Silverado 1500 Replaced dead battery. Signal lights are flashing and the truck is making a beeping sound. It won't crank, won't even turn over. Any thoughts? (this Ask Question doesn't offe...
1999 Chevrolet Silverado 1500 LT Extended Cab RWD
-
Maintenance & Repair
Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.