I am having problems starting the truck. Right now if the vehicle sits for a couple of hours it will not start unless I spray some starter fluid in the TB. THere are no diag codes. Have checked / replaced the MAF, MAP PVC. But once the vehicle is started it runs like a champ. If it does not sit long it starts right up. Thought maybe it was a tank of bad gas have run fuel injector cleaner thru the tank. Have not replaced the fuel filter yet. Any suggestions........

Asked by c_manche Jun 27, 2007 at 05:33 PM

Question type: Maintenance & Repair

I am having problems starting the truck.  Right now if the vehicle
sits for a couple of hours it will not start unless I spray some
starter fluid in the TB.  THere are no diag codes.  Have checked /
replaced the MAF, MAP PVC.  But once the vehicle is started it runs
like a champ.  If it does not sit long it starts right up.  Thought
maybe it was a tank of bad gas have run fuel injector cleaner thru the
tank.  Have not replaced the fuel filter yet.  Any suggestions........

415

mmeek answered 16 years ago

It sounds like the engine is starved during startup. Try replacing the fuel pump. This may be in the tank and tough to get at, but could be your problem.

1 people found this helpful.

Mark helpful

Your Answer:

I am having problems starting the truck. Right now if the vehicle sits for a couple of hours it will not start unless I spray some starter fluid in the TB. THere are no diag codes. Have checked / replaced the MAF, MAP PVC. But once the vehicle is started it runs like a champ. If it does not sit long it starts right up. Thought maybe it was a tank of bad gas have run fuel injector cleaner thru the tank. Have not replaced the fuel filter yet. Any suggestions........ 1 Answer

I am having problems starting the truck. Right now if the vehicle sits for a couple of hours it will not start unless I spray some starter fluid in the TB. THere are no diag codes. Have checked /...

GMC

-

Maintenance & Repair
04 gmc sierra 1500 5.3 died on me on the highway got it towed home starting going at it, hooked two different scanners to it and not throwing any codes (ecm is working bc the map was reading correctly but also the rpm was zero) anyways checked fire none checked injectors they wasnt working either(built fuel pressure then unplugged fuel relay then turned engine over and the pressure stayed the exact same) i assume it might be the crank sensor but i would think it would throw a code, anyways came back this morning and before doing anything for the hell of it i checked the gas cap and tightened it and it fired up perfect three different times and the last time i let it run and it died after bout 45 seconds (fuel pressure reads 55) and after it died its doing the same thing cranks but wont fire or start 1 Answer

died on me on the highway got it towed home starting going at it, hooked two different scanners to it and not throwing any codes (ecm is working bc the map was reading correctly but also the rpm was...

2004 GMC Sierra 1500

-

Maintenance & Repair
HELP! Ok i have a 96' GMC Suburban 5.7. trouble starting. 1)When i turn the key the wants to turn over but it is just flooding. 2) When i turn the key and pump the gas pedal it just flooding. 3)when i turn the key and hold the pedal to the floor(not pumping) it tries to turn but takes est. 10-15 seconds and starts. now once its started i can drive anywhere it seems. But when i turn it off same thing all over again to start it. in last 6months i put a new fuel pump and filter in it. someone said it is a cold cranking problem,but i can go out in the cold and hold the pedal to the floor,turn the key and after 10-15 sec of it trying to turn over it will start. just dont why it wont by just turning the key. 7 Answers

new fuel pump and fuel filter 6 months ago

1996 GMC Suburban K1500 4WD

-

Maintenance & Repair
i have a 2001 gmc savana 3/4 ton 5.7 vortec, i am having problems with a rough/low idle and it dies under load and has no power. i have replaced the fuel pump, fuel filter, spark plugs wires, plugs, rotor, cap, air filter, MAF sensor, TPS sensor, idle air control sensor, EGR valve. i am out ideas please help. By the way i have NO codes. 1 Answer

i have a 2001 gmc savana 3/4 ton 5.7 vortec, i am having problems with a rough/low idle and it dies under load and has no power. i have replaced the fuel pump, fuel filter, spark plugs wires, plugs,...

2001 GMC Savana Cargo G3500 Cargo Van Extended

-

Maintenance & Repair
I Have A 07’ Yukon SLT. And I been Having battery drainage problems lately.. it will be working Fine than one minute I while get back in it to drive and it will be Dead! Get a jump, it comes back on and be fine for weeks than one day it just dies again? Not sure what’s wrong? But what I did find out is that the owner before me had Speakers hooked up and the loose Wirer's are still running under my seats and in my truck the other end of the wiRers that ran to the speaker is just thier live wirers with nothing hooked to it? Could that possibly be why the battery is seen tobe draining and if So what could I do to fix it, or either how could I disconnect the wirers from the battery running live under my seats??? 4 Answers

I Have A 07’ Yukon SLT. And I been Having battery drainage problems lately.. it will be working Fine than one minute I while get back in it to drive and it will be Dead! Get a jump, it comes back o...

2007 GMC Yukon SLT1 4WD

-

Maintenance & Repair

Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.

1 Answer

Your Answer:

Shortcuts

Search GMC Questions

CarGurus Experts

Find great deals from top-rated dealers

1 Answer

Your Answer:

Related Questions

Shortcuts

Search GMC Questions

CarGurus Experts

Find great deals from top-rated dealers