2002 suburban cranks/wont start after ignition harness replacement

Asked by Feb 27, 2017 at 06:45 PM

Question type: Maintenance & Repair

I started having issues with headlights not wanting
to dim, turn signals still "ticking" after making a
turn, then I lost all dash gauges and the trans was
stuck in 3rd gear. Check engine code was for
ignition harness. I replaced the multifunction switch
first, then the ignition harness. After the harness
was installed the truck will only roll over, it will not
fire. A friend said I needed to reset the security
system, so I researched how to do that. The
problem is when I roll the key to the on position,
then attempt to start, then leave in the on position, I
don't have anything in the message center except
got a battery light. There is no flashing security light.
Any help is greatly appreciated, I'm out of ideas!

1 Answer

Anyone out there experiencing anything similar? I am thinking a factory reset on the security system at the dealer but wanted to check before I go shelling out $$$

Your Answer:

Chevrolet Experts

  • #1
  • #2
    John Carson
  • #3
View All

Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.