greetings all. i have a 2004 dodge neon se that quit on the highway two days ago. pulled code p0340. changed the camshaft position sensor about a month ago. changed the crankshaft position sensor yesterday. no help. i can hear the fuel pump energize when i turn the key. what comes next?

Asked by farbjorn Aug 10, 2017 at 12:31 PM

Question type: Maintenance & Repair

engine cranks like a champ but will not start.

60

GuruD9JG2 answered 6 years ago

How many miles on it?

1 people found this helpful.

Mark helpful

60

GuruD9JG2 answered 6 years ago

Sounds like timing belt broke.

1 people found this helpful.

Mark helpful

farbjorn answered 6 years ago

138k on it. timing belt is what I have been hearing all day. I'll check on it and report my findings here.

Mark helpful

Your Answer:

greetings all. i have a 2004 dodge neon se that quit on the highway two days ago. pulled code p0340. changed the camshaft position sensor about a month ago. changed the crankshaft position sensor yesterday. no help. i can hear the fuel pump energize when i turn the key. what comes next? 3 Answers

engine cranks like a champ but will not start.

Maintenance & Repair
I have a 2004 Dodge Neon it's a 2.0 and I replaced the camshaft position sensor and the throttle body position sensor because that's what it was telling the computer when I hooked it up at AutoZone. I replaced 1 Answer

I have a 2004 Dodge Neon it's a 2.0 automatic and the check engine light came on so I hooked it up at AutoZone and they told me it was telling them it was the camshaft position sensor so I change t...

2004 Dodge Neon SXT Sedan FWD

-

Maintenance & Repair
After replacing the harmonic balancer and driving I have a P0340 code camshaft position sensor "A" circuit malfunction bank 1 1 Answer

I replaced the harmonic balancer and timing sensor, after test driving I now have a code P0340 camshaft sensor "A"- circuit malfunction (bank 1) any suggestions how to correct it.

2006 Ford Explorer XLT V6

-

Maintenance & Repair
I got a P0340 on my '96 intrepid ES. Cam position sensor. I replaced it, but still no go. Put the diagnostic machine on, and still I get a P0340 code, even with the new sensor. What gives here? 1 Answer

I am only getting one code reading on the OBD reader, and that is the p0340. Not sure what the hell else is wrong, but i am not pushing any other codes. If I blew my timing belt, i am certain I would ...

1996 Dodge Intrepid ES FWD

-

Maintenance & Repair
I have a 2001 Silverado 1500 4.3 v6. I bought it used about a year ago, it throws the code "camshaft to crankshaft position correlation fault" and it has a slight miss that is worse when it's wet out. 4 Answers

I've replaced the ignition module, distributor, cap, rotor, and the crankshaft sensor. I can't figure out the problem. Could someone please help?!?

2001 Chevrolet Silverado 1500 LS RWD

-

Maintenance & Repair

Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.