Crank but no start

Asked by Robert Jun 18, 2017 at 10:19 AM

Question type: Maintenance & Repair

Truck cranks but won't start. I've checked/replaced
a lot of the HPOS but still notta

2 Answers

Robert answered 6 years ago

Found out yesterday that I used an OEM filter in an after market cap last time I changed the oil. Unaware of the difference of course. So basically I have been running unfiltered oil thru the motor for about 4000 miles. The IPR did have a bad seal, when I spray a little starting fluid into her. I Can get her to start and ICP tests good. I have zero low oil pressure on the gauge when cranking with no start but when it's running I have full low oil pressure, as soon as I let the rpm's get below 1000 it stops to zero. Do I need to pull the ENTIRE HPOS system apart and check for failure/debre or should replacing the filter and cap to its proper OEM PARTS FIX fix the problem?

Mark helpful
157,425

Bob answered 6 years ago

Apparently you would like us to guess what year, brand and model of vehicle you are talking about.........

Mark helpful

Your Answer:

Related Questions

  • Crank but No start 2 Answers

    94 ram 2500 no start .new crank sensor was installed.ive got 40psi fuel pressure to rail.im getting injector pulse and i have fire. I was driving and it died crank but no start. Compression is goo...

    1994 Dodge RAM 2500

    -

    Maintenance & Repair

  • Crank but no start 4 Answers

    I did an engine swap. It will crank but will not start. I used all sensors and brand new timing kit from the old motor. There were no problems other than loosing compression in cylinder 1. What cou...

    2005 Subaru Legacy 2.5i Limited Wagon AWD

    -

    Maintenance & Repair

  • Crank but no start 2 Answers

    Car won’t start I change fuel pump spark plugs wires crank shaft sensor camshaft sensor new battery new alternator car cranks but it doesn’t start what can be the problem

    2000 Hyundai Elantra

    -

    Maintenance & Repair

  • Crank but no start 1 Answer

    I got a Mitsubishi Eclipse that will crank but not fire up

    1997 Mitsubishi Eclipse

    -

    Maintenance & Repair

  • Crank but no start 1 Answer

    Check engine light popped for an O2 sensor, went to Oriellys to have it checked, had them clear it and do a batt test while i was there. Then it wouldn’t start. Didnt throw any new codes. Checked fo...

    1998 Pontiac Bonneville 4 Dr SSE Sedan

    -

    Maintenance & Repair

Shortcuts

Search Maintenance & Repair Questions

CarGurus Experts

  • #1
    Gene Arnett
    Reputation
    244,970
  • #2
    Rowefast
    Reputation
    183,550
  • #3
    dandyoun
    Reputation
    169,260
View All

Find great deals from top-rated dealers

Search

Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.