Crankshaft position sensor didn't work

Asked by Todd Aug 10, 2019 at 05:56 PM

Question type: Maintenance & Repair

Try to smog my truck didn't pass so I did a tune up
pugs, O2  air filter  when I was doing the distributor
cup and router I seen my distributor was broken so
I replied it after all that it runs good but I now have
a crankshaft position sensor code replaced the
sensor but it still codes. Running good though

1 Answer

New information comes to light got a better code reader code reads communication problem between crankshaft positioning unit and camshaft positioning unit suspect that I have the distributor off by a tooth going to fix it tomorrow and let you guys know thanks bye

Your Answer:

Maintenance & Repair Experts

  • #1
    G A Arne
  • #2
  • #3
View All

Find great deals from top-rated dealers


Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.