I found out my 96 s-10 blazer wouldn't shift into 4 wheel drive by getting stuck in a river bed, I replaced the actuator because the diaphragm was ruptured. the next time it didn't work I assumed the same thing happened, but when I checked, it was full of transmission fluid. If I understand correctly, the transfer case has an electric shift motor, so where is the fluid coming from? is the vacuum line tied into the down shift actuator on the transmission and that component have a ruptured diaphragm?

I found out my 96 s-10 blazer wouldn't shift into 4 wheel drive by getting stuck in a river bed, I replaced the actuator because the diaphragm was ruptured. the next time it didn't work I assumed the same thing happened, but when I checked, it was full of transmission fluid. If I understand correctly, the transfer case has an electric shift motor, so where is the fluid coming from? is the vacuum line tied into the down shift actuator on the transmission and that component have a ruptured diaphragm? 1 Answer

I am getting vibration from 25 mph to 55 mph in the drive train. When shifting to a lower gear going down a steep road I get a clunk. Sounds like U joints but they don't look loose. When I turn the drive shaft that is in front of the transfer case I hear a noise in the transfer case. Can U joints be bad but still appear tight? Can a transfer case be rebuilt like other components? 1 Answer

I have a 1994 S10 Blazer. It is a four wheel drive with the push button selector. Last hunting season I noticed that when I was in 4 wheel drive and I shifted down to keep my speed down on the moun...

where is the actuator located on a 95 chevy blazer 4x4 1 Answer

where is the actuator located on a 95 chevy blazer 4x4

I have a 89 s-10 4.3 blazer. It is cranking over but not starting. I can smell gas after trying to start it. I also put my finger under neath the injector and it had gas. I hear the fuel pump turn on. 6 Answers

i rebuilt the throttle body a year ago. I did not put a new throttle position sensor.

I have a 1999 blazer lt. Replaced trans motor, tccm, 4 button switch and finally atc fuse. I now have a service 4 wd code and when I start the vehicle the 4 button switch flashes and lights go out. 1 Answer

1999 blazer lt. Trouble occurred when I put transfer case in neutral. 4 button switch stopped working. Replaced tccm, 4 button switch and encoder motor. Still no lights on switch. Found fuse atc und...