Wheel Bearings - how to check?

125

Asked by Jeff3645 Apr 29, 2009 at 07:35 AM about the Chevrolet Lumina

Question type: Maintenance & Repair

Has anyone replaced wheel bearings on an early 90's Lumina? How do you tell if they are going bad, or if they're just fine?

1 Answer

95

They should be making noise if they're bad. Sometimes, brake pads can sound the same at slow speeds. I had this problem with my passenger brake pad. A whole chunk of it was missing and it resonate like a reed on a saxophone whenever I would drive backwards. If you're still thinking wheel bearing at this point, then jack the car up, and shake the wheel and see what play there is. Usually side to side motion is tie rods, so check those, and top to bottom motion is ball joints. But if those look tight then it could end up being the wheel bearings, which are a complete assembly and aren't cheap so make sure you are positive you need them before buying them!

1 people found this helpful.

Your Answer:

CarGurus Experts

  • #1
    90V6RedHotLuminaEuro
    Reputation
    1,670
  • #2
    John Saffrahn
    Reputation
    1,330
  • #3
    11jonny11
    Reputation
    1,190
View All

Find great deals from top-rated dealers

Search

Related Models For Sale

Used Chevrolet Monte Carlo
4 listings starting at $9,800

Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.