Asked by Bob Dec 20, 2014 at 11:27 PM about the Volkswagen Jetta
Question type: Maintenance & Repair
I am in the middle of swapping the transmission on my Jetta and am getting really frustrated because I can not get the spline on the transmission to go in to the torque converter. it has 2 splines on one shaft and a key way in the very back of the transmission. any advise would be greatly appreciated . thanks
Only suggestion I would have is you need some kind of trans jack so you can slide it straight in. Two different times I changed to a smaller torque converter with higher stall speed on TH400's and never had a bit of problems. I was using a home made bracket that fit in the saddle of my floor jack.
For future references, you have to keep spinning the torque converter until the splines eventually line up and will go into place since the mating spline gear wants to fall off centre it’s much easier to put the converter in place prior to putting transmission in..
I am in the middle of swapping the transmission on my Jetta and am getting really frustrated because I can not get the spline on the transmission to go in to the torque converter. it has 2 splines on ...
Volkswagen Jetta
-
Maintenance & Repair
I had the radio in my 2011 Jetta replaced twice while it was under warranty. Now it's out of warranty and the radio went again. But this time it comes on for like for 2 minutes and then goes off. ...
2011 Volkswagen Jetta Comfortline
-
Maintenance & Repair
Hi my daughter's radio went out on her 2011 vw jetta last week. The radio will not come on and the screen is black. Her phone will still connect with the bluetooth. We have tried the hard restart with...
2011 Volkswagen Jetta
-
Maintenance & Repair
Can anybody help me with a problem I believe I have on my 2006 Volkswagen jetta 2.5 5 cylinders. It doesn't seem to run as well as it use to I know i blew out the o2 sensor could that be part or th...
2006 Volkswagen Jetta 2.5L
-
Maintenance & Repair
Car starts fine, cleaned throttle body, replace MAP sensor, replace vaccum gasket due to oil leak. I do have a P2402 code which I will address tonight. The problem is the car will no longer move whe...
2013 Volkswagen Jetta SE
-
Maintenance & Repair
Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.