Rocam 1.3 2006 over heat

Asked by GuruB5T51 Dec 11, 2018 at 06:39 AM about the Ford Bantam

Question type: Maintenance & Repair

Rocam 1.3 2006 model overheat and you can stop for a moment. Then you
start and the heat gauge go back to normal.. Stay there and then all a sudden it
ramps up to the red. With the stop procedure it goes back to normal stay there
for a few kilometers then it does the same thing. Please help

2 Answers
16,445

Guru97FK8 answered 5 years ago

Perform an onboard Instument Cluster Test. It could be the wiring harness between the PCM and cluster. Check your fuses and relays are all OK.

Mark helpful
16,445

Guru97FK8 answered 5 years ago

To perfform the cluster test, Press the ODO trip button in and hold, switch the ignition to ON and wait till the ODO area on the cluster displays TEST. To scroll through the tests press the trip button. To exit the test , switch the ignition off.

Mark helpful

Your Answer:

Related Questions

  • Rocam 1.3 2006 over heat 2 Answers

    Rocam 1.3 2006 model overheat and you can stop for a moment. Then you start and the heat gauge go back to normal.. Stay there and then all a sudden it ramps up to the red. With the stop procedure it...

    Ford Bantam

    -

    Maintenance & Repair

  • need cylinder head gasket torque specs. Ford bantam 1.3 rocam 2006 2 Answers

    need cylinder head gasket torque specs. Ford bantam rocam, 1.3, 2006 model. Stood a while, and oil looks like mud, not starting. Want to change cyl head gasket.

    Ford Bantam

    -

    Maintenance & Repair

  • Ford rocam 1.3 heat gauge problem 5 Answers

    While driving long distance the heat gauge shows normal working temperature "in the middle". When I switch the bakkie off and start it again after a few minutes the heat gauge rise to almost overhe...

    Ford Bantam

    -

    Maintenance & Repair

  • my fan run constantly and my heat gauge stays cold what should b done For bantam Rocam 1.3 3 Answers

    I drive a ford bantam Rocam 1.3 the fan runs constantly the heat gauge even stays cold, now I feel like it looses power

    Ford Bantam

    -

    Maintenance & Repair

  • Ford bantum rocam 1.3 2 Answers

    My ford bantum rocam gives on but does not want to start or even crank the engine,what l noticed again the is a small red light near the watch that switches on when l turn on the car then off and ...

    Ford Bantam

    -

    Maintenance & Repair

Shortcuts

Search Ford Bantam Questions

CarGurus Experts

  • #1
    Guru97FK8
    Reputation
    15,140
  • #2
    Janus Welgemoed
    Reputation
    1,140
  • #3
    MrRocket12
    Reputation
    1,120
View All

Find great deals from top-rated dealers

Search

Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.