there is no power supply to the coil pack of my 1.6 bantam

Asked by GuruCC5Z1 Feb 17, 2019 at 07:28 AM about the Ford Bantam

Question type: Maintenance & Repair

theres no spark to plugs, no power supply to coil pack, where is the crank
sensor located in a 2007 1.6 bantam bakkie

12 Answers

6,925

The crank angle sensor is located by the fly wheel. Has the engine been replaced at any time ? The Fly wheel for the 2007 onwards is slightly different from the earlier engines , as this engine has 26 minus two teeth , compaired with the earlier engine which has 36 minus ONE teeth as a pick up for the crank angle sensor.

1 people found this helpful.

nothing done on the engine, the car overheated, then i replaced head gasket but the temperature gauge still shows that the engine is overheating.

6,925

Sounds like a thermostat problem. Check the Thermostat.

i have checked crank sensor an its ok but theres still no power supply to the coil pack, only the common wire is responding, the other two wires dead

6,925

The center wire to the coil pack is the live, There should be an ignition 12volt power supply there. The two outside terminals are both feeds to the Computer Box (PCM). these two are earthed at a frequancy through the PCM. The ignition power to the center pin on the coild pack will be the same as the power to the injectors. Check for open circuit between the Coild pack and the PCM.

thanks, where is the PCM situated in this vehicle and which relay or fuse is responsible for frequency to the coil?

6,925

The PCM is located on the left side 'A' Pillar, Right side under the dash. I would strongley recomend you take your vehicle to a reputable Auto Electrician or a RMI approved vehicle service outlet or vehicle repairer.

1 people found this helpful.
10

I have a 2007 Ford Bantam Rocam engine, the car starts ok, idle for about 2minutes or more and thereafter suddenly cuts off. I've replaced the coil pack (non-genuine) and leads but still faced with the problem of sudden engine cutoffs while idling. Please help.

1 people found this helpful.
6,925

Check the harness plug at the computer box. It could have water leaking into it.

1 people found this helpful.

Hi guys please help me here my Ford bantam rocam 2007 1.6 it starts nice and it drives but when I accelerate it looses power stat shaking and I have done the service what can be the problem?

6,925

Check the spark plug gaps. They should be 1.00mm. Chech the coil and the HT Leads.

Your Answer:

Bantam

Looking for a Used Bantam in your area?

CarGurus has thousands of nationwide listings and the tools to find you a great deal.

Postal Code:

Shortcuts

Ford Bantam Experts

  • #1
    Guru97FK8
    Reputation
    6,100
  • #2
    Janus Welgemoed
    Reputation
    1,020
  • #3
    AB Zaviour
    Reputation
    860
View All

Find great deals from top-rated dealers

Search

Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.