my 300m boils over after i shut the engine down but as ong as i drive it its fine and never overheats

Asked by auguamaster Jul 16, 2012 at 10:22 PM about the Chrysler 300M

Question type: Maintenance & Repair

bought the car 2 weeks ago had a bad radiator cap put a new one on it ever since the car boils out the water five minutes after i shut the engine off. I am a mechanic and have never had this issue on anything before has me completely baffeled. I have bled out the air throught the bleed screw. and checked the thermostat.

6 Answers

24,415

What temp does it run at when cruising down the road? Do you notice any oily residue in the coolant overflow? You might want to get a radiator cap that has a built in thermostat. You can compare that temp to the dash dial. How much of the coolant gets pushed out? Try taking radiator cap of with car warmed up,but no pressure in the system. Rev the engine slightly. You should notice the coolant level go way down and then as you release the throttle the coolant should overlfow. This will show condition of coolant pump.

2 people found this helpful.

The temp runs right below the halfway point on the gauge. When I pull the cap and rev the engine the level goes down but not very far. I have a lazer temp gauge the car runs right at 197.3 most of the time. I think I might have found the problem Last time it blew out the water when I refilled it after bleeding the air I would squeeze the radiator hose and more air would come out I jacked up the car so the air bleed was the highest point and poured water in to the bleed till it would not take anymore it has not lost any water since but I have not driven it far enough to really give it a good test. Thanks for the input.

10

I have the same problem sometimes it don't overheat. I changed the t- stat but still over heats but not all the time. I watch to see if coolant is flowing and it is but still overheats.

1 people found this helpful.

Finally found the real problem the radiator had a very small leak on one of the tank seals when the system would cool down and the antifreeze contract it would suck a small amount of air into the radiator instead sucking water from the overflow tank the system would get an air lock and overheat. put a new radiator on it problem solved.

With my 2001 Chrysler 300 m I just had the problem of boiling after turning down the engine Solution was radiator cap replacement that's thanks to this cargurus and the people who post experience here I also did the bleeding from the top of the engine but it's works better with engine hot just be very careful Hot gasses will come out

Your Answer:

300M

Looking for a Used 300M in your area?

CarGurus has thousands of nationwide listings and the tools to find you a great deal.

Postal Code:

CarGurus Experts

  • #1
    aztec626bf
    Reputation
    700
  • #2
    Chaddyboy
    Reputation
    660
  • #3
    meanoldmoe
    Reputation
    600
View All

Find great deals from top-rated dealers

Search

Related Models For Sale

Used Chrysler 300
29 Great Deals out of 544 listings starting at $4,790
Used Dodge Charger
31 Great Deals out of 972 listings starting at $4,888
Used Dodge Challenger
28 Great Deals out of 887 listings starting at $1,001
Used Ford Explorer
57 Great Deals out of 2,220 listings starting at $7,990
Used Chrysler 200
16 Great Deals out of 275 listings starting at $4,931
Used Jeep Grand Cherokee
110 Great Deals out of 3,487 listings starting at $4,950

Content submitted by Users is not endorsed by CarGurus, does not express the opinions of CarGurus, and should not be considered reviewed, screened, or approved by CarGurus. Please refer to CarGurus Terms of Use. Content will be removed if CarGurus becomes aware that it violates our policies.